Question about 2004 Chevrolet Express

1 Answer

How do you set the clock on a 2004 Chevy Express Van

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 6 Answers


The HR arrow is the left one and the MIN arrow is on the right.

Here's the instructions from the manual:

Press and hold the HR or MIN arrow for two seconds.
Then press HR until the correct hour appears on
the display. Press and hold MIN until the correct minute
appears on the display. The time may be set with the
ignition on or off.
Hold either arrow down for two seconds and then you can adjust the hour and minutes.


Posted on May 04, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 10 Answers

SOURCE: Wiring/electrical schematic info for a 2000 chevy express van

Check www.autozone.com.

Posted on Jun 14, 2009

johnjohn2

Johnny Brown

  • 5763 Answers

SOURCE: Where is the fuel filter located on a 2004 chevy

under van in front of fueltank near frame on driverside,hope this helps.

Posted on Oct 27, 2009

Jonah Oneal

  • 14092 Answers

SOURCE: I need the serpentine belt diagram for a chevy Express Van

DRIVE BELT DECAL SHOULD BE UNDER THE HOOD.OR YOU CAN GO TO DEALERSHIP GET ONE AUTO ZONE OR ADVANCE AUTO PARTS CAN GET YOU ONE.OR YOU CAN BUY A HAYNES REPAIR MANUAL IT HAS BELT DIAGRAM.

Posted on Mar 10, 2010

rjcnsons

  • 4 Answers

SOURCE: Reverse and interior lights out, chevy express van

Fuse block under the hood. Driver's side, under the brake master cylinder. Number 18. TCB#2. Replace the fuse.

There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block.

Posted on Aug 05, 2010

duane_wong

Duane Wong

  • 6826 Answers

SOURCE: How do you change the

Axle Shaft Bearing & Seal Removal & Installation To Remove:

  1. Raise and safely support the vehicle.
  2. Remove the axle shaft.
  3. If replacing only the seal, remove the seal using a suitable seal removal tool.
  4. If replacing the seal and bearing on the 8.6 inch axle, install the slide hammer and adapter behind the bearing and pull out the bearing and seal together.
  5. If replacing the rear axle shaft seal and the bearing on the 9.75 inch axle, install the J 29712 or equivalent bearing puller into the axle housing behind the axle bearing.
  6. Remove the axle shaft seal and the bearing by tightening the nut on the J 29712 bearing puller.
Use a slide hammer, bearing puller and adapter to remove the old axle bearing 88457g81.gif

To Install:
  1. Install the axle shaft bearing using a suitable size driver. Drive the bearing into the housing until the tool bottoms against the tube.
  2. Lubricate the seal lip and install the seal with a suitable seal driver. Make sure the seal is fully seated in the axle tube.
  3. Install the axle shaft.
  4. Fill the rear axle with the correct lubricant.
  5. Lower the vehicle.
prev.gif next.gif

Posted on Oct 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Instructions on installing headlight on 2004 chevy van


I loo9ked up owners manual for 04 chevy express van. Just want to add, use clean gloves, don't touch bulbs with bare hands. Just my opinion.
26117889-ukhdazury1tn4ov1h012spf5-5-0.jpg

Mar 04, 2016 | Cars & Trucks

1 Answer

How do I change the brake light on a 2004 Chevy Express van?


Just go onto google and type in how do I change a brake light on a Chevy express van you will be shown a video of how to do it hope this helps

May 30, 2014 | 2004 Chevrolet Express

1 Answer

Where is the fuel filter located on a 2004 chevy express van ?


under van in front of fueltank near frame on driverside,hope this helps.

Oct 27, 2009 | 2004 Chevrolet Express

2 Answers

2004 chevy 3500 express passenger van transmission


if ur replacing it remove front grill disconnect both lines and carefully remove retaining clips from radiator if replacement is original eguipt mount & reconnect --if its a universal follow instructions usually cut off fittings and use clamps and hose to hook up

Oct 27, 2009 | 2004 Chevrolet Express

2 Answers

Disc Brake Emergency brake adjustment on 04' Chev Express Van


Continually push the brake pedal to set the brakes. (With park brake off). Brakes are self adjusting and will adjust to correct position.

Mar 29, 2009 | 2004 Chevrolet Express

1 Answer

HEY WHERE IS THE THERMOSTAT LOCATED ON 2004 CHEVY EXPRESS CARGO VAN


you have to reove the front air filter look at the upper radiatir hose follow the hose to the engine its under that housing hope it FIXYA our problem thank you pierre

Jul 01, 2008 | 2004 Chevrolet Express

Not finding what you are looking for?
2004 Chevrolet Express Logo

299 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...