The FEM (Forward Electronic Module) is defective....See image #1...This necessitates a trip to the dealer in that replacement requires a Ford Diagnostic Tool...See Removal and Installation instructions below...You may find one on EBay...
Front Electronic Module(FEM)
Removal and Installation
CAUTION: Prior to removal of the FEM, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed..
Disconnect the battery ground cable..
Remove the instrument panel lower steering columnopening cover.
Remove the bolts. Thumbnail 1
Remove the instrument panel opening cover reinforcement.
Remove the bolts. Thumbnail 2
Remove the front electronic module(FEM).
Disconnect the five electrical connectors.
Remove the three bolts. Thumbnail 3
CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic toolinto the new module.
To install, reverse the removal procedure.
IMAGE 1:
Cost is high, Around $500
saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
SOURCE: rear cooling and heating blower motor does not work
its not in the headliner. its under the side panel in the rear on drivers side. you half to remove the panel on the inside just above the rear tire. since the moter runs sometime i would replace the blower motor resistor first cause these are known for going bad and its in the same area as the blower motor. this resistor controls the fan speeds and if its gone bad the fan dont run right. plus its alot cheaper than blower motor. once you have replaced the resistor you can turn the fan on and see if its a fixya before putting the panel back in place.
SOURCE: I have a ford windstar 2001 lx there are four code's i need info
#1 is the egr position sensor #4 Is for single cylinder misfire so this could be the coil or a bad plug or wire ..but with fords should check for a vacume leak that can cause a misfire to .....#2#3 are 02 sensors before i would change them i would check the mass air flow sensor ..Hope this helps
SOURCE: Remove the radio in a ford windstar 2000
There is a ford radio removal tool. It looks like a pair of horse shoes most times. Or you can insert four 8 common D finish nails in the four holes (or 4 six D finish nails) -one in each hole until you feel it click. Be gentile. simultaneously push each side towards their respective front door and gently pull the radio out.
SOURCE: 2002 Ford Windstar spark plug orientation
For the 3.8L:
Firing Order:
1-4-2-5-3-6
Cylinders:
....(back)
3............6
2............5
1............4
....(front)
Ignition Coil Pack Connections:
(back)
3....4
2....6
1....5
(front)
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com.
489 views
Usually answered in minutes!
×