Middle seat belt buckle tip for booster seats, car seats, and large humans.

Your best bet is to call your Honda dealer's parts department or a good salvage yard, either will probably be happy to answer this.

If I had the problem I would look at a junkyard or on line at e-bay for a replacement. You will need to get the buckle and the belt that it is attached to that goes down to the floor down through the crack in the seat.
Remember the buckle receiver is made for the certain belt in the front and rear seats. I have often tried to put the wrong belt in a buckle and it would not fit. ( Example: the right belt goes in the right buckle.)
Be blessed.

I don't know if this is something you want to get into? You decide. Front Seat Belt Replacement SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE: Check the front seat belts for damage, and replace them if necessary.

Front Seat Belt

1. Make sure you have the anti-theft code for the radio, and then write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Slide the front seat forward fully.

1. Pull the lower anchor cover (A) back, and remove the lower anchor bolt (B).
2. Remove the B-pillar lower trim panel.

1. Remove the upper anchor cover (A), and remove the upper anchor bolt (B).

1. Disconnect the seat belt tensioner connector (A), and detach the harness clip (B) from the retractor (C). Remove the upper retractor mounting bolt (D), and the lower retractor bolt (E), then remove the front seat belt (F) and retractor.
2. If necessary, remove the front seat belt protector (G).
3. Remove the B-pillar upper trim.

1. Remove the shoulder anchor adjuster (A).

1. Install the seat belt in the reverse order of removal, and note these items:
   • Assemble the washers, collar, and bushing on the upper and lower anchor bolts as shown.
   • Check that the retractor locking mechanism functions.
   • Apply liquid thread lock to the anchor bolts before reinstallation.
   • If the seat belt tensioner has been activated, replace the front seat belt protector with a new one.
   • Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
   • Make sure the seat belt tensioner connector is plugged in properly.
   • Reconnect the negative cable to the battery.
   • Enter the anti-theft code for the radio, and then enter the customer's radio station presets.
   • Reset the clock.
   • Do the PCM idle learn procedure and the power window control unit reset procedure.

Upper anchor bolt installation
Lower anchor bolt installation

Seat Belt Buckle

1. Make sure you have the anti-theft code for the radio, and then write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the front seat.
4. If equipped, remove the center table.
5. Remove the under seat storage box.
6. Remove the center cover, driver's, passenger's.

1. Driver's: If equipped with seat heater, remove the harness band (A), and disconnect the seat subharness connector (B). If equipped without seat heater, detach the seat belt switch connector clip (C). Detach the seat belt buckle tensioner clip (D), and harness clip (E).

with a SCANNER.
your mechanic or Honda Dealer will provide this service....
Disconnecting the battery won`t do you any good.
You will have to fix the air-bag problem first before you can erase the airbag light...

Hi should be done every 100,000kms my husband says and has always done so on all his cars, says it;s cheap insurance.Margaret