How to change a waterpump on a1995 chrysler le baron

I would check the under the hoop power distribution center.

are you talking about pollen filter

Need to know which engine you have in your car. If a v6 it could be a 3.0 or a 3.3 liter engine. The eighth digit in your vehicle serial number identifies the engine. Get that digit and call your local dealer service manager and ask him what you have. After that you may be able to find a how-to video on you tube.

You might try changing the fuel filter, most likely the fuel pump is going out and will need to be replaced.

sounds like it is going into limp mode,

The torque settings for oil pan replacement is 11ft lbs.

If all you did was remove the pan and service it then 3 and 3/4 liters will fill it. If it was rebuilt and has no fluid at all then it will take 8 and 1/2 liters

Enough to fill the brake fluid resernoir.

This will take some digging. You would be money ahead to go to a parts store and buy a haynes or chilton manual for 20 dollars. The waterpump is ran by the timing belt, so you will want to replace that to. You also need to know how to line the timing marks up to get the belt back on right. The manual will give you all the info you need.

Have you checked it for spark?