1997 Hyundai Elantra Logo

Related Topics:

How do I replace the bulb in the middle brake light in a 1997 Hyundai elantra

5 Related Answers

Anonymous

  • 1665 Answers
  • Posted on Jun 23, 2008

SOURCE: thermostat in a 1997 hyundai elantra

See exploded view
0d68e80.gif

REMOVAL
1. Drain the coolant down to thermostat level or below. 2. Remove the coolant outlet fitting and gasket. 3. Remove the thermostat

Ad

Anonymous

  • 1 Answer
  • Posted on Dec 26, 2008

SOURCE: How do I change the back brake light of a Hyundai Elantra?

If it is the light in the rear window, there are two plastic caps on either side on the base of the light. Pop off the cap and remove the screws inside. That should allow you to get to the bulb. I went to autozone for the bulb w/o removing it and they gave me the wrong one. If you have the bulb removed, you're better off, if not, the people at advanced got me the correct one without any issues. If it's the brake lights on the back of the trunk, you access those from inside the trunk. On either side, there are thumbscrews (sometimes under the fabric lining flaps). Once you remove the bulb carrier, you'll know which one is out. It usually lines up with the red cover but if you can borrow someone's time, have them look in your trunk at the bulbs as you test your parking lights to see which one lights and which one doesn't. Hope this helps.

Anonymous

  • 1214 Answers
  • Posted on Feb 03, 2009

SOURCE: bulbs keep burning out

When you replace headlights in today's cars, DO NOT TOUCH THE GLASS OF THE BULB!. Handle the bulb only with the packing material the bulb ships in, or with a clean dry cloth.The oils in your skin will cause premature failure of the bulb.

Also, check the sockets (car side) carefully to make sure they are not burned.

USfalcon

anwar alkhaldi

  • 197 Answers
  • Posted on Mar 16, 2009

SOURCE: How to replace headlight bulb hyundai elantra 2004

yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx

Anonymous

  • 776 Answers
  • Posted on Jun 20, 2009

SOURCE: Fog Light Bulb 2008 Elantra

Simple to do.

3624ae9.gif

5e693d8.gif

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

The driver side running lights don't work on my 2007 hyundai elantra. brake light, blinkers and headlights all work and the bulbs are good because they flash when i lock car with the fab. but they don't...

brake lights and blinkers use the sale filament in the bulb
the running light is the other (in a dual filament bulb)
you may have a poor connection or a break inside the bulb base.
test with a known good bulb.
the next place to look is the connector on the light switch and the joint where the running lights split off.
0helpful
1answer

2001 hyundai elantra brake lights not coming on checked fuse is good bulbs look good what could it be

Have you tested or replaced your brake light switch at the brake light petal?
Best regards,
Ck
Please provide feedback
5helpful
3answers

2002 Hyundai Sonata brake lights stuck on.

Check brake switch located near the pivot point on brake pedal move switch with your finge and see if it's stuck, May need new brake switch.
0helpful
1answer

2002 Hyundai Elantra Brake Light Problem? This is a Girl thing, I am so car stupid!!! I have a 2002 Hyundai Elantra. Both brake lights are not working (but the brake light in the rear window does). I have...

Did you replace the correct lights? are you positive they were the brake lights? There is a little tester you can buy that you pust against the fuse if it is good a light on the tester lights up green. You can get them at almost any automotive store.
1helpful
1answer

01 Hyundai Elantra - Cruise Control Doesn't Work w/ Headlights On

I had same problem (cruise control/dashboard lights) for the past month with my 2000 Elantra. Replace the tail lights bulbs - my problem was caused by a problem with the double filament within the bulb. Essententially, there was a short when I turned on the lights or hit the brakes.

I did this last night and everything is working properly now.
0helpful
1answer

My 06 Elantra's brake lights won't come on. Bulbs

The brake sensor switch is located on the brake pedal. If fuses and bulbs are ok it should be the switch.
Not finding what you are looking for?

74 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...