How do I remove and install a new window into my driver side rear door in my 1996 acura tl, step by step please?

SOURCE: how to remove door panel on 1997 acura tl

Follow this link. There is detailed step-by-step info here
Please kindly let me know if it works for you
Good Luck
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008c18d

SOURCE: How do you remove the door panel on a 1997 GMC 1/2 ton trucks?

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f768
Hope this helps!

Marvin

• 85242 Answers
• Posted on Feb 28, 2009

SOURCE: Where is the starter located on a 1996 Acura 2.5 TL?

it is at the rear bottom of engine, points inside the bell housing of the transmission, u will need to jack the car off the ground to see it and get at it for repAIR

SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel

This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal

SOURCE: Where is the starter on a 1996 Acura 3.2 TL? On a

grantgga2: I don't think this is one you are going to want to try to change out.
It entails having to remove the left axle and part of the exhaust pipe to gain access to the starter. At that point, you have one bolt which goes in at the bottom from the starter side and bolts to the engine. The other bolt passes through the trans axle housing and bolts into the starter, pulling it up to the engine.
SCARED YA HUH? I'D SAY FROM A 1-10 FOR A WEEK END WARRIOR, IT WOULD BE ABOUT A 6.
Was I helpful?