Changed the whole exhust system all the way up too the 2)manifolds & 4) o2 cencors (catalyas convertors a well)...when hooked up to the machine it only reads p0420 as the only problem, which in terms mean o2 cencor or catalyas convertor (left hand side in the rear)... now i do have a part tht i aint get a chance to properly fix , which is where the convertor @ the tip clamps to the muffler,could tht be the problem or some thing else ?...
SOURCE: i need to locate the crank shaft cencor on my 1999
The crankshaft position sensor is located on the right rear of the engine block, (where the transmission bolts to the engine).
Testimonial: "thank you for the information i have not had time to see if i can locate the censor yet, but i will let you know as soon as i have the time. Thank you"
SOURCE: engine light comes on, have
The numbers are grouped in twos.
12 Memory standby power lost (this means that you must have disconnected your battery. It will turn off in the next 50 key cycles.
34 Speed control vacuum or vent control solenoid circuits.
32 EGR system
55 end of codes it will always flash 55 informing you that it is finished
Hope this helps give feedback and good luck FixYa
77 views
Usually answered in minutes!
×