At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
www.autozone.com/.../Ford-Freestyle-2005/.../Starter/_/P-099...AutoZoneFord Freestyle 2005. REMOVAL & ... Remove the transaxle roll restrictor bolts and the cross brace assembly. Remove the ... Remove the starter from the vehicle.
ALSO PICTURES ON GOOGLE
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You may need to shim the starter out from the engine. When you removed the original starter did you also remove a small piece of metal that would have been between bellhouseing and starter. If so this piece should have been put back. Good Luck Friend.
on a ford stater its almost impossible to rub the flex plate/ fly wheel however if the bendix gear spring is weak the stater drive can get stuck on the fly wheel and make a whining sound. if that is the case you will need to replace the starter if its a grinding sound its something totally different.
The big red battery wire goes to the bigger terminal on the starter solenoid.There may be another red wire smaller in diameter but the eye should be same as the battery wire that also goes to the to the same solenoid terminal.
The third wire small again ,might be yellow/orange or red with a small eye goes to the start terminal on the starter solinod.
Hi
DO NOT put a bigger fuse in ,you need to find out why the fuse blew in the first place,it is unlikely to be the starter motor,it could be a bad connection,the mercedes all have problems with the ignition switch assembly this is more likely.
Check and see how much your alternate is putting out. Make sure that your battery cables are clean. Check the water in the battery. It sounds more like a connection problem than stater.
take the negative side off the battery put the car on ramps secure the rear end so it does not roll and if you need a diagram for removing and installing the starter try autozone
×