SOURCE: what is the average cost for labor and parts to fix the exhaust?
It depends on the area your in as to how much labor and parts are being charged.
here in waco tx. a factory installed exhaust would be around 600 - 800 dollars,a aftermarket exhaust would be about half that.
Please dont forget to rate this solution
SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks
have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.
SOURCE: 1996 chevy blazer 4wd rear hatch and window does
owners manual page 2-9 peel back or **** the carpet locally to expose the access hole in trim panel on endgate use a thin screwdriver to reach through the access holes in both th trim panel and the hardware cover. pry the release lever toward the passenger side until the glass latch pops open.
SOURCE: how much will it cost to replace the rear
In my area it can be done for about 800.00 plus the cost of the rear.And in my opinion if the rear is rebuilt with a new ring and pinion gear that's the biggest part of the rear then I consider that along with new axle seals and differential gasket it would be almost new.This would save a large sum of money for one that's rebuilt.
134 views
Usually answered in minutes!
×