SOURCE: Will a rear end out of E350 Ford interchange with a Chevy 3500 dually
Is the c/k 3500 4 wheel drive?If it is 4WD,you must retain the same gear ratios for both front and rear axles,or the transfer case will be damaged.If it is 2 wheel drive,you can install any gear you like.I believe the Ford E350 rear axle is a Dana 70,as i have rebuilt 2 of that model,along with Dana 60's.The Ford unit likely will not be a bolt in.It will probably require professionally welding new mount brackets on the Ford axle housing.The width needs to be measured from inside the brake backing plate to the other brake backing plate to see if it will physically fit.Good luck.
SOURCE: how to tell what gear ratio i have in my truck
No tag on door pillar or door telling you? Or try ( www.decodethis.com )
SOURCE: gear ratio
There are two different ratios for a S10 Blazer,a 3.42(GU6) and a 3.08(GU4).Look in your glove box for a GM option codes.Look for a GU6 or GU4 code for the type of ratio you have.Hope this helps.
SOURCE: 1994 gmc rear axle removal how to
-Remove tire and brake drum
-put drain pan under axle housing
-remove rear axle housing cover (10 or 12 bolts)
-turn gear untiil the bolt for cross shaft shows and remov e the bolt
-remove the cross shaft.
-push axle in until you can remove "U" clip from axle and axle will pull out,
Remove seal, you need a pulller to remove axle brg.
323 views
Usually answered in minutes!
×