Evaporative (EVAP) Emission Canister Purge Solenoid Valve (2.2L Engine)
RH side of engine above the coil packs. this is from Chevy factory service manual . Is yours missing ?
Hi there. We still cannot find it. Right hand from what location?
Ignition coil's ,do you see them .
Does your's have a plastic engine cover
×
SOURCE: purge solenoid location
which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. i'll answer both, lol
the locations are described as if you are looking at the engine from the front of the car with hood open.
on the blazer:
it is located on the left side of the intake manifold just under and behind the throttlebody. it is a canister looking device.
on the silverado:
it is located on the intake manifold on the left side in about the same spot as the blazer. providing the silverado has the 5.3 or 5.7 liter engine. if it also has the 4.3 then obviously it will be the same.
hope this helps!
SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?
You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett
SOURCE: where is the purge valve located on a 2004 honda LX?
It is with a 2 wire Black connect located next to the throttle body. Locate the green cap on the evap hose and follow it to the throttle body and that is the purge valve.
SOURCE: Location of the Purge Control Valve for 2003 Hyundai Tiburon
There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
And the 2.7 Liter V6:
http://schematicsdiagram.blogspot.com/2011/12/how-to-disconnect-hose-form-evap.html
-------------
4,976 views
Usually answered in minutes!
×