Where can i find vacuum diagram for a 2003 s10

Your engine is 2RZ-FE engine. It and the 3RZ-FE in 1997 had the same vacuum diagram. Here it is....

please be more clear. Which Vacuum Hose Diagram you are looking for. What is the problem you are facing . Please elaborate so I can help you further.

Not sure of your engien size as you didn't say so I went with the most common enegine the 3.8 liter. Again I wasn't sure of what vacuum diagram you needed as the is vacuum for emissions, air conditioning and cruise control. the picture above is for emissions for the 3.8 liter engine. Hope this was what you were needing but if you have a different engine (305 or the 3.8 turbo) you can reply back here with what diagram you needed or the correct engine. Hope this helps...

The diagram of the vacuum system of this engine is under the hood on the federal emission system sticker.

Pop the hood of the car and locate the serpentine belt routing diagram. The diagram on the 2003 Chevrolet Impala is on top of the fan shroud. The diagram will be a picture of all of the accessory pulleys and how the serpentine belt is routed among the pulleys. This diagram will give you the exact direction for routing the new belt onto the pulleys. If you cannot find a serpentine belt routing diagram, take a notepad and pen and draw out the exact routing diagram of the old belt across the pulleys.

2 Locate the serpentine belt tensioner. It is located below the alternator on the left front side of the engine. The tensioner on the 3.4 liter, 3.5 liter and the 3.9 liter engines will require a 3/8 ratchet to release the belt tensioner. The 3.8 liter engine will require a ratchet and a 15 mm socket for the belt tensioner. Rotate the belt tensioner clockwise to loosen and remove the belt from the belt tensioner pulley.

3 Slide the old belt from the belt tensioner pulley. Remove the belt from the remaining pulleys and pull the belt from the engine compartment.

4 Route the new belt across the crankshaft pulley first. The crankshaft pulley is the big pulley on the bottom of the engine in the center. Then route the serpentine belt across the remaining pulleys as directed by the serpentine belt routing diagram. Leave the belt tensioner pulley for last.

5 Rotate the belt tensioner clockwise again to relieve the tension and slide the new belt across the top of the belt tensioner pulley. Release the belt tensioner and the belt will tighten up as the tensioner applies pressure to the belt. Make sure the new belt is properly seated in all the pulleys.

6 Crank the engine and inspect the belt again to make sure that it stays seated in the pulleys.

Read more: How to Replace a Serpentine Belt on a 2003 Chevrolet Impala ' eHow.co.uk http://www.ehow.co.uk/how_6120665_replace-belt-2003-chevrolet-impala.html#ixzz1Yi6QLAjb

possibally the purge canister

Here is a website that a free manual can be down loaded for your vehicle


http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

this mite help you

well do not no if its an 8cy or 6cy but if 6cy its 142536 if 8cy 13726548 looking at motor 1234is on passengers side 5678 on driver same gose for the six cylinder

You didn't specify your engine so please choose the applicable one:

2003 Ford Escape 2WD
2.0 liter DOHC L4 VIN "B"



2003 Ford Escape 2WD
3.0 liter V-6 VIN "1"



2003 Ford Escape 4WD
3.0 liter DOHC V-6 VIN "1"