Remote Control Door Lock Receiver (RCDLR)
On the left I/P sound insulator
Where is the i/p insulator0 then. Lol
Do you know where the OBD2 connector is ? It's above that on the back side of the insulator panel . Plastic panel above your knees when sitting in the driver seat.
There it is... lol. Thank you
Your welcome .
×
1. Locate the red two wire programming connector located near the central
locking control module. Behind LH lower instrument panel.
2. Inside the red programming connector you will see two pins.
Jump the two pins with a section of wire. A paper clip bent in a "U" shape will also work.
3. System should now lock and unlock doors to indicate vehicle has entered
programming mode.
4. Press any button on keyless remote once. System should now lock and unlock
doors indicating the keyless remote has been programmed.
5. Repeat step 4 to program the other remote.
6. Remove jumper wire from programming connector to exit programming mode.
7. Test Remote(s).
459 views
Usually answered in minutes!
×