Trouble codes p1494, p1784 and p0700?

codes are OBDll and are available on line free.

https://repairpal.com/obd-ii-code-p0102
https://repairpal.com/obd-ii-code-p0113
https://repairpal.com/obd-ii-code-p0700

P0700 Transmission Control System Malfunction

what does code p1714 mean

P1784 Your best bet is take your vehicle to AAMCO or some other transmission repair shop . If cost's to much to fix you may want to get a new one .

p1784 shift up /down wire open,,,P0700 Transmission Control System Malfunction

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

P0732 Gear 2 Incorrect ratio

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

The transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. When the TCM detects a malfunction with the control, a signal is send to the Engine Control Module (ECM) to trigger the Engine Light or Service Engine Soon light. The ECM stores the P0700 code and it means the TCM detected a malfunction with the transaxle controls.
Read more: http://engine-codes.com/p0700_dodge.html#ixzz3Pn5lTBcI

p1781 is manufacturer control transmission, p0731 is gear 1 ratio incorrect, p1784 is manufacturer control transmission, p0700 is trans, control system malfunction. all of these codes refer to tranny.This code normally points to a faulty transmission control module, but this is an expensive part and you should have an experienced Dodge technician diagnose the problem first. or a transmission specialist. the other codes are probably associated with the p0700 code. have a good day !

try this site it might be of some use..its 2000 on...

http://www.troublecodes.net/chrysler/00avseb.shtml

What are the trouble codes? Can be a lot of things, but still sounds like an ignition problem (bad coil pack?).

OK, GOT IT YES THE RANGE SELECTOR (THAT IS THE FORMAL NAME) SWITCH CAN CAUSE THIS ISSUE

buy a couple bottles of gas line antifreeze and add them to your tank.... each time you fill up add one to the tank

(DTC) CODE # P0700....Transmission Control System (MIL Request)

Translation: Transmission Control Module (TCM) Malfunction or Failure.

P0700 Information Code

The Transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. If any malfunction is detected, the TCM informs the PCM by sending a signal (P0700 code). P0700 means that a code has been set in the TCM.

This code is for information ONLY. If this code is present, check for transaxle codes.

So basically, the P0700 code is telling you to check the TCM for a transaxle DTC. The TCM can not turn on the check engine light so it has the PCM do it. It needs to be scanned with trans capable scanner to see what the trans code or problem is. You should have 1st, 2nd, and Reverse because the car is operating in limp-mode. Since you said the speedometer doesn't work, my guess would be a faulty (VSS) vehicle speed sensor.