My 2002 isuzu rodeo 2wd 4cyl won't crank, when I turn key all lights come on as normal, but won't crank. It will push start and runs after it is started. replaced crank shaft sensor, as that code was showing from the check engine light.
You may have a bad starter. It'll run after you push start it because it's not using the starter to crank the engine. If you bring it the starter, some auto parts stores will test your starter for you.
Doing my best to help you with this one. The clutch pedal starter switch is a definite possibility.
I'm not too sure of it's location, but I would start by looking under the dash by the top of the clutch pedal. Most likely that is where it is. Another possibility could be your ignition switch, but I would test the clutch pedal starter switch with an ohm meter first.
×
Make shure your baterie haves abaut 13 amps
then check your starter solenoid make shure that curent is geting there wen you turn the key
566 views
Usually answered in minutes!
Checked battery, took out starter and had tested and was fine.
Checked battery, took out starter and had tested and was fine.
had starter tested at the store, they said it was good. Replaced crank shaft sensor but that didn't do it. Put starter back and took a test light and can't find a problem.
Could it be the clutch start switch? Reading manual, but it does not say where this is located, only that it is part of the starting system. Please help. How do I check this and where is it?
Could it be the clutch start switch? Reading manual, but it does not say where this is located, only that it is part of the starting system. Please help. How do I check this and where is it?
×