Do you have fuel pressure? Check schreader valve on fuel rail for fuel pressure (push little pin in and see if fuel squirts out) If not, your pump is not working. if you do, you may have a cam or crank position sensor that is not working.
SOURCE: location of fuel filter on volvo s80 year 2000.
its under the engine on the side of the frame
SOURCE: need to know what motor oil is best for my 2000 volvo s80 with 150k
any major brand is ok (Pennsoil, Quaker state etc.), use 10W-30W
SOURCE: 99 Volvo S80 water pump replacement
if this helps.. I had the 1998 model S70. the water pump was driven by the timing belt. you had to take the timing belt off just to replace the water pump. it was just a simple bolt on replacement. the only difficult issue is resetting the hydraulic tensioner on the timing belt. the hydraulic tensioner has to be completely taken off and compressed VERY SLOWLY in a vise. then insert a very hard drill bit or (special volvo tool) into a keeper hole, reinstall hydraulic tensioner onto car and reinstall timing belt.very quickly remove drill bit from keeper hole in tensioner and the tensioner snaps back out to put tension on belt. and you are done.
SOURCE: 2000 volvo s80
0237 is turbo/ super boost sensor a circuit malfunction
0236 is turbo/ super boost sensor a ckt range performance
SOURCE: How do I replace the fuel filter on my 2000 Volvo S80
The gas filter is located passenger side just forward of the rear axle. The band that holds the gas filter in place is a pinch band that has a nut welded/formed into it on the back/top side. A 12 mm bolt holds the band in place. The top of the band has a bracket that hold the return fuel line - this just pops off and the return fuel line can be reattached once the filter has been replaced. If your filter has never been replaced there is masking tape covering the pinch connections at both ends of the filter. Remove the masking tape. You need to put a pan under the old filter to catch any gas spillage - it will be minimal. Also the new filter comes with plastic caps on the ends of the new filter - you will want to use them to plug the old filter connectors so you need to take them off the new filter to have handy. Ther is a T off the inlet gas line that has a cap on it - remove the cap and press the needle in the T to relieve any pressure that is on the gas line - If it has been setting for an hour there will probably be very little if any pressure on the line. You can skip messing with the T and you will see about an ounce of fuel that will come out of the filter when you remove the hose.
To remove the connectors push the connector ring away from the filter housing. (I did the front first because I had more room). I used a paint can opener to help pry the hose away from the filter - it is shaped like a can opener but without a cutting edge - a large flat screwdriver would perform as well. It is a tight fit but once it starts to move it will come off. Once the hose is off use the plastic caps you took off the new filter to help hold the gas in the old filter. After removing both ends remove the holding band and place it on the new filter. The two lines will go back on easier than they came off, just push them onto the filters nipples. Put the 12 mm OR 10MM bolt back into the pinch band and reintall the return fuel line.
157 views
Usually answered in minutes!
×