Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Oct 06, 2015

Knocking rattling noise from engine appeared while driving loss lil power running but loud knocking in engine

1 Answer

Russell Mower

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Cars & Trucks Master 372 Answers
  • Posted on Oct 07, 2015
Russell Mower
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Aug 25, 2009
Answers
372
Questions
0
Helped
76558
Points
1193

You didnt state vehicle however if the engine knocks the knock sensor will back off the timing thinking its detination not an actual knock if its knocking loudly stop driving it, something is going to let loose

5 Related Answers

Anonymous

  • 13 Answers
  • Posted on Apr 03, 2009

SOURCE: Camry engine knock and loss of power

Sounds like you've blown her up. An engine starts knocking when the bearings are worn to the point of being loose. I wouldn't keep starting her up. If I'm right(and the odds are on me) you'll sling a rod through the block or the oil pan.
If you can get the oil pan off do so(after uyou drain it of course) and grab the rods one at a time and find out which one(or more) that's giving you the problem.It(or they) will be loose around the crank shaft.
Good luck,but for Heavens sake DON'T start it again until you check those rods.

Ad

Anonymous

  • 1 Answer
  • Posted on Jun 01, 2009

SOURCE: VW T4 2.5 TDI engine makes rattling noise no loss

hi. that noise is the vacuum pump knocking. it should stop if you press the break pedal a few times or pull the pipe of the break servo. £120 on ebay half hour job to change

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Jun 09, 2009

SOURCE: 2004 Nissan Quest - Engine chatter/knocking

Ther e is a chance your injectors are leakin g down and there is excess fuel in the cylinders. Not a good thing. So, you fuel pressure and injectors need chkg. good luck

Anonymous

  • 1959 Answers
  • Posted on Jun 10, 2009

SOURCE: oil consumption, rattle, engine noise

Check under the hood and inspect the valve cover gasket. If it's bad it would explain why you don't see any leaks on the ground because it's probably burning off on the manifold. This ticking you're hearing is a lack of lubrication to the rocker arms. Apart from the valve cover gasket, you should get under the car and inspect the oil pan and oil filter for seepage. Best of luck on your problem.
Greg

Anonymous

  • 1 Answer
  • Posted on Aug 24, 2009

SOURCE: engine or transmission knock / rattle upon

I had the same problem on my 2006 Lucerne and it was the engine mount located on the front of the vehicle behind the radiator.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

What's the torque on rod bearings?

Engine Noises ' Knocking and Ticking ' Common Causes

www.justautorepair.com/whats-wrong-with-my.../knocking-ticking
The following are causes of connecting rod bearing noise: ... Loose torque converter-to-flywheel or flywheel-to-crankshaft bolts will sound similar to bearing knock. .... I got a 1998 tahoe its making a lil ticking noise after I got unstuck on some ice ... 2001 FordTaurus with a loud mechanical noise that is constant when engine ...

Change 4.6L rod bearings with engine still in vehicle? 02 Explorer ...

www.ford-trucks.com > ... > Modular V8 (4.6L, 5.4L)
Aug 11, 2011 - The regular everyday rattling noises seemed to get louder than usual. ...So I dropped the pan and this is what I found: ... Is it possible to change the rod bearings with the engine still in the vehicle? ... If you decide to go with new bearings,torque your caps down on some plasti-gauge and see if you get the ... 7.3 engine r&r
Mar 22, 2012
Rod Bearing Replacement
Dec 27, 2010
More results from www.ford-trucks.com
0helpful
1answer

My 05 chevy equinox is making a loud knocking sound. Going down the road I lost all acceleration and breaking but still had my lights and instrument panel. Pulled over and restarted the car and it has been...

is it engine related- or drive train related- with the loss of power I'd say its engine related-what is your oil level like- a noise like that could be pretty bad-spun rod bearing-hope not-Denny
0helpful
1answer

Loud rattling noise when cold in reverse or drive

Check engine mount or exhaust mount/damage
0helpful
1answer

Rod knock upon start

Not sure on model but to me sounds like its a dodgey valve lifter when the seals start to go they cannot hold the oil and when there under pressure they basically empty them selves hence when you turn the engine off and restart you get a rattle sound untill the valve fills again as long as the cars running ok leave it untill you have to replace them unless there easy to do sone are sone are a pain
1helpful
1answer

Loud knocking noise engine

Have a oil pressure test done on the engine to determine bearing failure. Have a compression test done to check for internal damage such as broken rings/pistons or overheated motor.. If the noise appears during acceleration then run the fault codes and look for a tuning problem or failed knock sensors
1helpful
1answer

Loss of power and engine making rattling noise

Run fault codes and look for failed knock sensors. I would suggest that the rattling noise is detonation from a lean fuel mixture-ignition timing or faulty EGR system. Detonation is when the fuel ignites with out the use of spark and occurs early as the piston is coming up so the piston is slammed against the cylinder walls. Prolonged detonation will cause melted holes in the pistons tops and broken rings so I would advise you fix this problem as soon as possible.
0helpful
1answer

What could be the cause of a rattling noise but engine never shuts off. No Mil. Alerts or any stuttering. just loss of power and loud knocking noise the more you rev it?

I have had personal experience of a head gasket blow the dodgy mechanic who re-built my motor at the time did not clean the head bolts and so they were not tensioned properly (I digress). Anyhow it blew between two cylinders - man what a racket! I thought my engine was kaput. In short my answer is head gasket - could also be a burnt out valve but most likely something in your top end of the motor.
1helpful
1answer

My loyale starts and runs ok, but makes a terrible noise, coming from the engine area. It sounds like a very loud knocking, clicking, sort of sound. It doesn't seem to affect the running of the...

hi a loud noise like the one you described can really only be a few things, either the main engine bearing is getting worn and is on its way out or you have a damaged or dirty lifter. The main difference between the two is the bearing will sound like a knock or grinding noise and the lifter will be more like a loud tick from either the left or right head on the motor you may just have to listen carefully to tell but it is possible and they will both speed up with the engine rpm. A bearing will usually cause problems running/starting/idling etc so maybe lean towards a lifter if it is damaged it will need an expensive replacement but try an oil change first as this can also free up dirt etc and solve the prob
0helpful
1answer

Flashing oil light/ loss of power

Check your converter on your exhaust when it's running and see if the noise of rattling is coming from there.If it is you have a plugged converter,it's broken up and in piece's which will make noise and no power especially when calling for power.Be sure to let exhaust cool before repair is done.If the engine is making the noise like a knocking sound you should bring it to have it checked.Hope this help's.
Not finding what you are looking for?

506 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...