Driver side mirror light remains on - 2007 Lincoln Aviator

Try changing the the little electrical motor that changes the ancle of the mirrors. But before that check your mirror fuses, if both sides doesnt work..

you can not replace just the glass. you need to replace the whole mirror. sorry

The following is from 2002 Honda Odyssey factory manual page 20-70: Driver's switch panel removal. (This is the switch panel to the left of the steering wheel with TCS, cruise control, mirror, and sliding door switches.) Gently pull on the driver's switch panel bottom right corner to release the (2) right side clips, then detach the remaining (2) clips on the left side and the single top center clip. If equipped, disconnect the cruise control main switch connector, TCS switch connector, power mirror switch connector, and power sliding door connector, then remove the panel. Once the panel is removed, you can push out the switch from the rear. The switch has two bulbs in it, one is the cruise switch backlight bulb and the other is the cruise control function bulb.

How do you change a light bulb on the passenger side mirror of a 2006 ford expedition?

SECTION 501-09: Rear View Mirrors 2002 Explorer/Mountaineer Workshop Manual REMOVAL AND INSTALLATION Exterior Mirror Glass Removal
NOTE: Exterior mirror glass is serviceable only on vehicles built after July of 2001.

NOTE: Passenger side exterior mirror shown, driver side exterior mirror similar.
All mirrors

1. Position the glass in the full up position.

1. Locate the notch at the bottom of the exterior mirror glass.

1. Release the exterior mirror glass.
   1. Insert a long flat-bladed screwdriver in the notch.
   1. Push the screwdriver into the notch until the glass is released.

Heated mirrors

1. Position aside the exterior mirror glass.

1. Disconnect the electrical connectors.

All mirrors

1. Remove the exterior mirror glass (17K707) passenger side or (17T675) driver side.

Installation
Heated mirrors

1. Connect the electrical connectors.

All mirrors

1. Position the exterior mirror glass on the exterior mirror motor.

1. Place a hand against the back of the exterior mirror housing and a hand flat against the exterior mirror glass. Press the glass in place until fully seated.

The exterior mirrors:

• are controlled by power controls on the LH front door trim panel.
• are of a foldaway design.
• may contain turn signal indicators.
• may be heated when the heated back window glass is activated.
• may have a programmable recall memory option.

Driver Seat Module
The power driver seat and power exterior mirrors are controlled by the driver seat module (DSM) only when the vehicle is equipped with the programmable/recall memory option.
---------------------------------------------------------------------
Power Exterior Mirror Operation
The power exterior mirrors are controlled by the DSM and are operational all the time, whether the ignition switch is on or off. Using the power exterior mirror switch, the driver can adjust the driver and passenger exterior mirrors four ways.
-----------------------------------------------------
Visual Inspection Chart Mechanical Electrical

• Exterior mirror(s)
• Interior mirror

• Central junction box (CJB) fuse
• Circuitry
• Exterior mirror control switch
• Exterior mirror motor
• Interior mirror
• Driver seat module (DSM)
• Memory set switch

----------------------------------------------------------------------------------

1. If the vehicle is equipped with memory exterior mirrors and the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel. Select the vehicle to be tested from the diagnostic tool menu.
   • Check to make sure the program card is correctly installed.
   • Check the connections to the vehicle.
• Check the ignition switch position.

-------------------------------------------------------------------------------------

• The mirrors are inoperative

• Circuitry.
• Central junction box (CJB) fuse.
• Exterior mirror control switch.

slide the rubber boot up and check the wires in the hinge of the doors. I will bet anything that the wires are broken. that was what was wrong with mine. just splice them back together and everything should work fine.

Start with a good thick pair of leather gloves, a putty knife, and a tall trash can. Place the trash can below the mirror, tilt the mirror inward so you get a hold of the outer edge, and carefully pry the remaining pieces of mirror from the backing plate. Do not apply any pressure directly to the backing plate, or you may damage the gears on the electric motor. You should be able to pick up a new mirror and adhesive at your local auto parts store. Use masking tape and a couple of wood blocks to hold the glass in place while the adhesive sets (blocks against the glass, then wrap the whole thing in tape).

     You have broken wires in the flexable harness between the door and the body. Pull the rubber boot back to inspect.

You will need to remove the triangular panel on the inside of the door on the opposite side of the broken mirror. Once you remove the panel, you will see the retaining bolts holding the mirror in place. Once you remove the bolts, the mirror can then be pulled out from the outside. Reverse the procedure to reinstall the new mirror.