Brake line diagram ABS routing - 2004 Chevrolet Silverado 1500 Crew Cab

Question edited for clarity.
Question moved to model category.

ABS is an electronic management system. Brake line diagram in the link.

https://www.google.com/search?q=Kia+Sedona+brake+line+diagram

..

just go to any auto parts store and ask them to give you a diagram print out they did it for me.

Diagrams are next to non existent

Have to duplicate what is there,always
been that way

Brake line diagrams dont exist like wiring diagrams do. If your truck has ABS, that's the ABS controller, and if not it's just the proportioning/metering valve.

is it only the rear brakes you cannot bleed or all of them ??

KIND HARD TO GET A BRAKE LINE DIAGRAM.YOU HAVE TO A SALVAGE YARD LOOK FOR CARS WITH THE N BODY SAME YEARS AS YOUR CAR IF YOU HAVE A OLDS ALERO A 99 MODEL LOOK FOR BUICK SKYLARK , OLDS ACHIEVA AND GRAND AM, THE MALIBU AND OLDSMOBILE CUTLASS.LOOK AND FOLLOW THE BRAKE LINES ROUTING FROM MASTER CYLINDER TO UNDERNEATH THE CAR.BRAKES LINES HAVE TO BE AWAY HOT ENGINE EXHAUST MANIFOLD AND PIPES.BRAKES LINES HAVE TO BE AWAY FROM ENGINE OR DRIVE TRAIN THAT CREATES VIBRATIONS WHICH CAN CAUSE BRAKE LINES TO BREAK.BRAKE LINES HAS TO BE SECURE IN BRACKETS.WHEN YOU GO TO SALVAGE YARD LOOK AT CARS I LISTED ABOVE.SAME BODY STYLE TAKE NOTE DRAW DIAGRAM ROUGH DRAFT OF HOW BRAKES LINES ARE ROUTED AND SECURE IN BRAKETS.THAT WILL GIVE YOU A IDEA WHERE TO RUN NEW BRAKE LINES.

Turn the ignition key to the "on" position but do not start the engine. Look at the lamps on the instrument cluster, there should be an abs light that shows. You can also open the hood, and follow the brake lines from the master cylinder. If the vehicle has ABS (and it should for that year and model) the lines will route to an ABS controller (which looks like a big metal "block" with a number of brake lines running to it and will probably say ABS on the housing.

If it's a metal line, Your local auto parts store should be able to order it for you or worst case you'll have to make your own from straight tubbing and a bender. I don't recall ever seeing diagrams for metal lines, usually there pre made to replace the factory one or you can splice a replacement piece in place of a damaged section. AS far as the line goes to the module, try following it up to it with a good flahlight and a sharppe from the rear forward.

Hello,
I hope this helps.







Thank You,
Roy

brake problem in 1996 ord taurus