You need to find out what code or codes are stored in the airbag control module > There are a lot of components involved in your airbag system : If you haven't had any training on these systems your best bet is take it to a ASE certified repair shop . People have been killed messing with these systems not knowing what they were doing .
The frontal SIR system consists of the following components:
?€¢
AIR BAG indicator located on the instrument panel cluster (IPC)
?€¢
Driver and passenger knee bolsters
?€¢
Inflatable restraint front end sensor
?€¢
Inflatable restraint PASSENGER AIR BAG ON/OFF indicator located on the instrument panel
?€¢
Inflatable restraint Passenger Presence System (PPS)
?€¢
Inflatable restraint I/P module
?€¢
Inflatable restraint I/P module disable switch
?€¢
Inflatable restraint seat position sensors (SPS) (left/right)
?€¢
Inflatable restraint sensing and diagnostic module (SDM)
?€¢
Inflatable restraint steering wheel module
?€¢
Inflatable restraint steering wheel module coil
?€¢
Inflatable restraint wiring harnesses
?€¢
Seat belt pretensioners (left/right)
?€¢
Steering wheel and column
SOURCE: 2000 chevy express 1500 van having starting issues
Start with fuel system. Listen for fuel pump humm at fuel tank No humm check wiring to pump for power. Then check for spark at plugs and wires. Remove wire from coil and hold near engine and see arch when you crank. No arch. Replace ignition Modular inside distributor cap or cap or rotor
SOURCE: air bag light wont go off after cycling 04 chevy express
YOUR VEHICLE HAS DETECTED A FAULT IN THE AIRBAG CIRCUIT IT WILL HAVE TO HAVE CODE RETRIEVAL DONE TO DETERMINE WHAT CAUSE LIGHT TO STAY ON,I URGE YOU TO DO THIS SOON AS WHEN AN AIRBAG SYSTEM HAS GIVEN A FAULT CODE AND TURNED ON THE LIGHT THE SYSTEM IS DIABLED AND WILL NOT PROVIDE PROTECTION IN ACCIDENT
Testimonial: "I tried what you suggested, and it worked the light cycled an went out thanks , david"
SOURCE: Reverse and interior lights out, chevy express van
Fuse block under the hood. Driver's side, under the brake master cylinder. Number 18. TCB#2. Replace the fuse.
There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block.
SOURCE: Check engine light lit. P0894 or P0984 error code.
Fixed error code P0894 - They replaced torque
convertor, solenoid, filter and did a flush.
578 views
Usually answered in minutes!
×