When I turn on the radio or the CD player, either will play for about 10 seconds, then cut out for 10 seconds, turn on for 10 seconds etc.... Can anyone tell me what the issue is an how I can fix it? Thanks
SOURCE: Mercedes Benz C180 Fault Message Brake Assist.Visit Workshop BAS
Hi there
BAS is the Brake Assist System and if there is a malfunction it would
only come into play in an Emergency stop while applying full pressure.
BAS applies full braking force because people tend to lighten up their
pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.
Kind regards
Dustin Ellse
SOURCE: i need the mercedes benz 1999 clk 430 radio code
AR82.60-P-7502-01A Coding Radio
(MODEL all with CODE (750) Radio Becker Europa 2000 with CODE (751) Radio Becker Grand Prix 2000 with RDS)
AR82.60-P-7502-01B Coding Radio
(MODEL all with CODE (353) Audio 30 APS with CODE (510a) Radio MB Exquisit with traffic news decoder, with RDS (Becker) with CODE (512a) Radio MB Special with traffic news decoder, with RDS.)
SOURCE: mercedes c class w203 heater not working
heater motor brushes are a common fault on ALL C class Mercs.
New brushes can be picked up on ebay for £12.50. Its a 30 min job to change them.
SOURCE: Mercedes c180 2002 model
Well the first thing i would do is scan the computer for codes,but without a scan reader you cant. see if it has fuel preasure,start there.
SOURCE: How do I remove and replace the radio in a 1993
First thing is to understand you will most likely have to run all new speaker wire as the head unit in your car has everything external to the head unit (power amplifier, fader). The plastic around shifter pulls up off, then remove wood surround. Remove ashtray, pull face off head unit usually by sticking fingers in cassette area and pull. There will be plastic tabs on the bottom of unit push in and pull out on head unit, pull slowly so you can inspect wires for placement. Again rerunning speaker wire should be done to preclude external amps and fader switch and power antenna if yours still works.
Testimonial: "Thanks so much. This is very helpful!"
156 views
Usually answered in minutes!
×