Location posts.
so you know it has a CB but cant find it.
well this car really is a 1997 toyota corolla and that makes finding out facts 1000x more easy. (lots more made)
i thing the corolla holds the record on max made, like 40million?
i forget.
But i diverged.
i dont usually do easter egg hunts.
but here goes.
I login to mitchels and look.
ok as expected, no breaker, why not ask how to use a voltmeter and find true cause, or read the schematic.
IG1 feeds the wiper fuse, called wiper front.
photos posted to fixya sux but here goes.
but wait if the washer works then the fuse is NOT BAD.
so does it?
does wiper fail in all modes? low ,fast , mist, int and flash mode.?
suxs yes, tiny useless fixya photos.
fuse is in the fuse box. marked WIPER
can show real schematic, and with any volt meter this is childs play, be happy its not 3 computers talking like k , my 2010 car.
no symptoms posted.
we can work symtoms, and wipers can do lots of bad acts, no one stated. by you.
dead, or sticks 1/2 way or keeps blowing fuses, or? what?
×
SOURCE: how to install power steering belt on 97 geo prizm
Most likely the belt and pulleys are shiny if you look at them, replace the belt, while you have the belt off try and clean the glaze off the pulley groves, this will make the new belt "grip" better and avoid slipage.
SOURCE: 1996 geo prizm
you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.
SOURCE: 1994 GEO Prizm Fuel Guage
You need to replace your fuel sending unit. It is located inside of the gas tank.
Please remember to rate this solution.
SOURCE: location of fuel pump relay on a 1990 Geo Prizm
under the hood in a fusebox near the firewall
SOURCE: Adjusting the headlights on a '97 Geo Prizm
on each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
272 views
Usually answered in minutes!
×