Question about 2010 Dodge Grand Caravan

1 Answer

Power lock drivers sliding door lock wont unlock

It doesnt work manully or remote key

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Dodge Expert
  • 267 Answers

The lock is in door mechanism that holds the door closed

Posted on Jan 17, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: 2002 Dodge Grand Caravan Driver Door Lock/Unlock Switch

sorry not sure the 12v prob will help this swtich works on 5v off 3v unlock 1v lock single wire lock/unlock logic signals
I found wiring diagrams at
http://www.dodge.com/bodybuilder/2004/docs/wd/rswd/tc.pdf
it is 2004 but use the wiring diagrams to test the wires
(most likely to fail where they flex)
because it is using logic gates disconnect the plug at each end of the wire you are testing or the damn thing will find a few diffrent ways to trick you.

Posted on Apr 21, 2009

Robert Debison

  • 412 Answers

SOURCE: 2006 Dodge Caravan - ONE power door lock stopped working

i have replaced many sliding door lock actuators on these vehicles..dealer part..mostly on passenger side sliding door..also possible you have a broken wire in door track harness..follow wiring from door into what looks like a plastic chain in door track at door opening

Posted on May 14, 2009

Dave Leoni

  • 66 Answers

SOURCE: 2004 Dodge Ram 1500 Quad Cab Drivers side power door lock broken

Sounds like the link rod to the latch are jammed in the locked position by something inside the door or it came off. Any way, you have to remove the door panel to get access to it.

Posted on Jun 03, 2009

jerry emmons

  • 116 Answers

SOURCE: Grand caravan sliding doors problems

the door track cable on the right side will have a broken wire in it,the drivers side will be the door control module inside the door

Posted on Sep 04, 2009

apocono74

  • 4 Answers

SOURCE: 2005 Grand Caravan power door lock quit working.

The lock actuator is probably broken in that door. We got one of the internet for 80$ and replaced it outselves and it solved this problem. IOD fuse is very temporary fix as system is sensing problem and flipping to protect itself like the breaker switches in the house.

Posted on Mar 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Both Power Locks Lock But Wont Unlock. Remote will unlock the doors


If the remote key fob locks and unlocks the doors then the problem is more than likely the power lock switches, this is a common problem on the Venture Van.

Mar 02, 2013 | 2001 Chevrolet Venture

2 Answers

How do I get my key remote to lock/unlock my toyota rav4 2002 model? I changed the battery because I thought that was the problem but it is still not working. The red light on the remote comes on but then...


You will need to try reprogramming the remote 1st, below is the complete procedure. If the reprogram doesn't restore function then you will need the dealer to test the keyless entry system, you may have a bad module or remote (only applies if both remotes don't work).

Start with the key out of the ignition, drivers door is open all others closed and
drivers door is unlocked.

2. Perform these steps within 5 seconds.
A. Insert the key into the ignition(Do NOT Turn) Pull key out.
B. Insert the key into the ignition(Do NOT Turn) Pull key out.

3. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into the ignition(Do NOT Turn) Pull key out.

4. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Close the drivers door
D. Insert the key into ignition and leave it in ignition.
E. Turn the ignition to ON (Do NOT Start) then back to OFF.
F. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should lock then unlock automatically
indicating successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
B. Immediately after letting go of the lock and unlock buttons,
Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door
locks should lock and then unlock once indicating successful programming. If
the door locks cycle twice, repeat steps A and B in step 6 as the remote was
not accepted.
C. Repeat steps A and B in step 6 for each new remote.

7. Open drivers door.

Aug 24, 2011 | 2002 Toyota RAV4

1 Answer

The lock on the driver side sliding door was stuck unlocked. Now it stuck locked.


you should clean the locking mecanism and then lubricate with WD40. If this is a van, my van has a sliding power door on the pass side and a manual slider on the drivers. alot of times the drivers locks and dont lock like it has a mind of its own but it always works with the drivers controls. and then the next time i dont think about it and it works. now it also has child proof locks on them, a little plastic lever you slide up and down as to put in a lock position so child cant open from inside and down to allow door to open from inside. double check this. it wont unlock with the key or power? you might have to take off inner door panel to manually unlock this and get it lubed

Jan 14, 2011 | Dodge Grand Caravan Cars & Trucks

1 Answer

I unhooked the battery now i cant stop the horn and it wont start the remote key does not work it got washed in clothes help please.97 camry


Lock then unlock the doors with the power lock button, with all doors closed (key not in ignition). If this doesnt work, try again using the key to lock and unlock from the driver door, with all doors closed.

May 12, 2010 | 1996 Toyota Camry

1 Answer

Car doors wont lock with remote


Sounds like the rod that goes from the lock to the key came off. There is usually a little plastic clip that holds it together and they break and you get what you are experiencing. You have to take the inside panel off of the door to get inside it.

Jul 05, 2017 | Peugeot 406 Cars & Trucks

1 Answer

Driver and Passenger auto door locks are inop.


Sounds like bad wiring, or bad door lock actuators. Check for power while locking/unlocking the doors.

Jun 29, 2009 | 2003 Chevrolet Astro

1 Answer

Drivers door power lock wont work.


Either the wring going to that motor or the motor itself is bad.

Mar 08, 2009 | 2000 Toyota 4Runner

1 Answer

2000 Safari, power locks,Rear dutch door wont unlock,


can you use the key its self on the rear door. what i mean is not using the remote but actually using the key?

Dec 19, 2008 | 2000 GMC Safari

Not finding what you are looking for?
2010 Dodge Grand Caravan Logo

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...