DTC P1519: IAC Valve Circuit Malfunction
Turn the ignition switch ON (II).
Is DTC P1519 indicated?
YES -
Go to step 3.
NO -
Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the IAC valve and the PCM.n
Turn the ignition switch OFF.
Disconnect the IAC valve 3P connector.
Turn the ignition switch ON (II).
Measure voltage between IAC valve 3P connector terminal No. 2 and body ground.
Is there battery voltage?
YES -
Go to step 7.
NO -
Repair open in the wire between the IAC valve and the PGM-FI main relay.n
Turn the ignition switch OFF.
Check for continuity between body ground and IAC valve 3P connector terminal No. 1.
Is there continuity?
YES -
Go to step 9.
NO -
Repair open in the wire between the IAC valve and G101.n
Disconnect PCM connector B (25P).
Check for continuity between body ground and PCM connector terminal B23.
Is there continuity?
YES -
Repair short in the wire between the IAC valve and the PCM (B23).n
NO -
Go to step 11.
Connect IAC valve 3P connector terminal No. 3 to body ground with a jumper wire.
Check for continuity between PCM connector terminal B23 and body ground.
Is there continuity?
YES -
Go to step 13.
NO -
Repair open in the wire between the IAC valve and the PCM (B23).n
Remove the jumper wire from the IAC valve 3P connector, then reconnect the IAC valve 3P connector.
Turn the ignition switch ON (II).
Measure voltage between body ground and PCM connector terminal B23.
Is there battery voltage?
YES -
Substitute a known-good PCM and recheck. If the symptom/indication goes away, replace the original PCM.n
NO -
Replace the IAC valve.n
826 views
Usually answered in minutes!
×