Question about 2006 Hyundai Tiburon
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
there are alot of harnesses to unplug.they missed a few by the sounds of it.
the cruise control is a cylinder that is vacuum operated and connected to the throttle cable.
check the vacuum lines and the wiring and make sure no wiring has been damaged installing the new engine.look for a plug that has clean looking pins,as the plug on an 8 year old car is clean on the inside.
Posted on Jun 13, 2009
SOURCE: 2001 HYANDAI ELENTRA car was stuck in 3rd gear changed turn signal fuse was blown changed fuse work fine for a short time then then fuse blowed again then trans stop shiftinh again i changed the outpu
I would suspect you have a short in the wiring to the transmission or the shift solenoid inside the ****** is shorted. Only way to know for sure is to get the wiring diagrams and trace down and inspect all the wiring that the fuse powers.
Posted on Sep 12, 2012
Tips for a great answer:
Dec 21, 2016 | Hyundai Motor 2003 Elantra
Jan 03, 2016 | Hyundai Cars & Trucks
Oct 09, 2015 | 2006 Hyundai Tiburon
Dec 19, 2014 | 2006 Hyundai Tiburon
following are the general instructions on the start of diagnosing any
electronically controlled engine or transmission problem.
The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM or ECM,ECU), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.
Oct 30, 2012 | Hyundai Motor 2000 Tiburon
Aug 13, 2012 | 2003 Hyundai Tiburon
Jul 20, 2011 | 2003 Hyundai Tiburon
Jul 10, 2010 | Hyundai Motor 2000 Tiburon
Jun 23, 2010 | Cars & Trucks
Dec 17, 2009 | 2006 Hyundai Tiburon
268 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: