Clean the throttle body and idle air control motor(Maf sensor if you have one). Check the air filter, replace if needed.
Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard ...
repairpal.com > Problems > Ford > Probe
Ford Probe Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard Starting, Poor Performance. This is a verified problem based on 9 reports. Learn more ...
Starting Problems - 1997 Ford Probe - RepairPal
repairpal.com > Questions > Ford > Probe > 1997 Ford Probe
Dec 5, 2010 - Starting Problems on 1997 Ford Probe ... If the engine runs rough,stalls, hesitates on acceleration, is hard to start, or has generally poor ...
A new misfire/hesitation on accel. Problem.. - ProbeTalk.com Forums
forums.probetalk.com > Tech Section > 2nd Gen (93-97) V6 2.5L
SOURCE: i have a 93 ford probe se the fuel cutoff light is on
when you are traveling about 35 or 40 mph press the brake just hard enough to make shudder let off do it again let and off. if you can control the shudder that way then its the brake if does not do it til you slow to a certian speed then the problem may be engine related. As far as the low idle there is an idle stabilizer which can definitely cause that problem. Or in some case an aged timing belt can cause similar issuses
SOURCE: location of fuel filter on 1995 ford probe
On all models except the Millenia, the fuel filter is attached to a bracket located in the left rear of the engine compartment, next to or beneath the brake master cylinder fluid reservoir.
SOURCE: 1997 Ford F150 4x4 5.4L
I would take the truck to an autoparts store and have the fault codes retrieved from the computer. Most stores will do the scan for free. I would lean toward a faulty throttle position sensor, but that's just speculation. The fault codes should narrow the problem down. Hope this helped and best wishes.
633 views
Usually answered in minutes!
×