Brake lamp indicator remains on

Any broken wire?

You can try to replace all the brake lamp bulbs as sometimes eventhough all bulbs are working but one of them is about to blow and give high resistance. That's why the brake lamp lights up.

Did u change the bulb w/ the Honda's original BULB? They have a different type BULB in honda, the amperage and the base contact is different from a regular bulb. Hope that helps u out! taah!

Rotors ,calipers and brake pads ,do not have any sensors, that communicate to the powertrain (computer)

Any type of light on your dash,indicates, that you may have a system failure somewhere ,or need the light reset.
Never assume work you pay for, was done correctly, or that something like your light wasn't missed.

You will have these issues going forward ,at least once a year,with current technology

Remain calm and educate yourself,ask a lot of questions

I assume you mean the one on the dash. This is an indicator that there is a problem in your braking system. Make sure it's not low on Brake fluid and have the brake system checked or check it yourself. If your going to check it yourself I recommend the Haynes repair manual on your vehicle as a reference.

Wow, that's a tough one. I had a 1979 Honda Accord that had a door sensor image that lit whenever a door or hatch was open. I never had a problem with it, however.

Actually, if it was a fuse, then the lights wouldn't light up at all on the dash.

1991 was a good year for Honda.

Alternator not charging by if all lamps are lit

This light is controlled by the hand brake,brake fluid level and on some models the brake pad wear indicators.
Low brake pads or a broken sensor wire is a common reason for this problem.

Likely one of the wheel sensors. Check that the master cylinder reservoir and ABS unit have enough brake fluid. When the light is on, ABS is disabled, the brakes should continue to work just like a car without ABS.

brake in a car is verry important for your saffety and others. that why they install many devices or systems to control them and make shure they work propely 1; brake light switch on the pedal floor(to indicate to the folowing car that you are stoping) 2;brake sensor fluid level (on the brake master cylinder under the hood)
to monitor the level of the fluid in the reservoir 3; brake pressure sensor (on the brake dispencer under hood) will warn you in case of brake pressure faillure .note, it may be more sensors, depending on the make of the vehicle but this is the tree comon causes for brake ligth to stay "on"