DODGE JOURNEY SERVICE REPAIR MANUAL 2009 2010 DOWNLOAD
for easy and best solution go to this link
DODGE JOURNEY SERVICE REPAIR MANUAL 2009 2010...
Buy and Download COMPLETE Service...
SOURCE: How do I check the transmission fluid on a 2009
below is info from the owners manual. I do not have a repair manual, but you may be able to buy one that would say how to check the transmission fluid on the 3.5L. It sounds like they don't expect you will need to check it. Fluid Level Check - Vehicles with 3.5L Engine The automatic transaxle has no dipstick and is dealer serviced only. Fluid Level Check - Vehicles with 2.4L and 2.7L Engines Use the following procedure to check the automatic transaxle fluid level properly: 1. Park the vehicle on level ground. 2. Run the engine at curb idle speed for a minimum of 60 seconds. 3. Apply the parking brake fully. 4. Place the shift lever momentarily in each gear position ending with the lever in PARK. 5. Wipe the area around the dipstick clean to eliminate 6. Remove the dipstick and determine if the fluid is hot or cold. Hot fluid is approximately 180°F (82°C), which is the normal operating temperature after the vehicle is driven at least 15 mi (24 km). Hot fluid cannot be held comfortably between the fingertips. Cold fluid is at a temperature below 80°F (27°C). 7. Wipe the dipstick clean and reinsert until seated. Then, remove dipstick and note the reading. a. If the fluid is hot, the reading should be in the crosshatched area marked "HOT" (between the upper two holes in the dipstick). b. If the fluid is cold, the fluid level should be between the lower two holes in the area marked "COLD." If the fluid level is low, add sufficient fluid through the filler (dipstick) tube to bring it to the proper level. Do not
the possibility of dirt entering the transaxle.
overfill.
SOURCE: 2010 dodge caravan
On the bottom of the auto transmission there is a belly pan, this pan must be removed to drain the fluid out of the transmission and replace the internal fluid filter. So you will need a large drain pan to catch the fluid and a floor jack to raise the van and safety stands to support it while you remove the bolts that hold the pan on, there is no drain plug so this is a VERY messy job. Clean off the old gasket completely, use no sealer and use a high quality trans pan gasket, the dealer is best or you will have leakage problems, tighten the bolts to 12-14 pounds of torque with a torque wrench, this is very important.
SOURCE: lights on driver's side don't work
most dodge have two fuse box one under the hood and the other open the driver's door there should be a fuse box on the side of the dash board
Testimonial: "Thank you, my wife misplaced the manual."
SOURCE: how to check the engine code 2009 dodge journey sxt
Actually you can check codes with out a scanner on Chrysler , Dodge products ! Dodge Read Check Engine Light Without Code Reader
3,508 views
Usually answered in minutes!
×