Question about Cars & Trucks

1 Answer

I have 2006 taurus and no manual or labels on fuses need to know what fuse is for radio

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,826 Answers

The fuse you want to check is the F1-17 fuse in the battery junction box. This is the radio fuse.
The number F1-17 fuse is the red/yellow power wire at the radio. If the fuse is good pull the radio and check the red/yellow wire for power in, if you have power in , then suspect a bad radio.My next step would be to remove the radio and check the power wire going into the radio (red/yellow) . If you have power there, then the radio is likely bad. Ford has had major problems with the radios.

Posted on Feb 16, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
keemo68

Ronald Mueller

  • 1263 Answers

SOURCE: Fuse for the radio on a 2001 Ford Taurus

do you have a owners manual? this will show the location and the purpose of each fuse and relay. the radio fuse should be red in color and be located in the fuse panel on the drivers side it is a 15 amp and is red in color... hope this helps you...please rate this thanks

Posted on Sep 02, 2008

warlock61

warlock61

  • 659 Answers

SOURCE: I need a fuse box diagram for a 95 ford taurus

send me e-mail address for diagram

Posted on Nov 23, 2008

michigan man

edgar walker

  • 3533 Answers

SOURCE: diagram and to know what each fuse is for on a 2000 ford taurus

the diagram is on the lid of the box and in the owners manual if no manual try one online from www.edmonds.com

Posted on Mar 21, 2009

emissionwiz

Marvin

  • 85222 Answers

SOURCE: Where is the fuse for the fuel pump. Not the reset

these are located in the underhood fuse box
Position #16 20A* Fuel Pump Relay
position #30 fuel pump relay fuse.

Posted on Nov 13, 2009

moparhart

Steve Hart

  • 246 Answers

SOURCE: I have a slow battery drain on a 2006 Jeep

Hi
Welcome
Jb power is Junction Block power
Here is a list of tests for this problom

IGNITION-OFF DRAW TEST The term Ignition-Off Draw (IOD) identifies a normal condition where power is being drained from the battery with the ignition switch in the Off position. A normal vehicle electrical system will draw from five to thirty-five milliamperes (0.005 to 0.035 ampere) with the ignition switch in the Off position, and all non-ignition controlled circuits in proper working order. Up to thirty-five milliamperes are needed to enable the memory functions for the Powertrain Control Module (PCM), digital clock, electronically tuned radio, and other modules which may vary with the vehicle equipment.
A vehicle that has not been operated for approximately twenty days, may discharge the battery to an inadequate level. When a vehicle will not be used for twenty days or more (stored), remove the IOD fuse from the Junction Block (JB). This will reduce battery discharging.
Excessive IOD can be caused by:

  1. Electrical items left on.
  2. Inoperative or improperly adjusted switches.
  3. Inoperative or shorted electronic modules and components.
  4. An internally shorted generator.
  5. Intermittent shorts in the wiring.
If the IOD is over thirty-five milliamperes, the problem must be found and corrected before replacing a battery. In most cases, the battery can be charged and returned to service after the excessive IOD condition has been corrected.
1. Verify that all electrical accessories are off. Turn off all lamps, remove the ignition key, and close all doors. If the vehicle is equipped with an illuminated entry system or an electronically tuned radio, allow the electronic timer function of these systems to automatically shut off (time out). This may take up to three minutes. See the Electronic Module Ignition-Off Draw Table for more information.
ELECTRONIC MODULE IGNITION-OFF DRAW (IOD) TABLE Module Time Out?
(If Yes, Interval And Wake-Up Input)
IOD IOD After Time Out Radio No 1 to 3 milliamperes N/A Audio Power Amplifier No up to 1 milliampere N/A Central Timer Module (CTM) No 4.75 milliamperes (max.) N/A Powertrain Control Module (PCM) No 0.95 milliampere N/A ElectroMechanical Instrument Cluster (EMIC) No 0.44 milliampere N/A Combination Flasher No 0.08 milliampere N/A 2. Determine that the underhood lamp is operating properly, then disconnect the lamp wire harness connector or remove the lamp bulb. 3. Disconnect the battery negative cable. 4. Set an electronic digital multi-meter to its highest amperage scale. Connect the multi-meter between the disconnected battery negative cable terminal clamp and the battery negative terminal post. Make sure that the doors remain closed so that the illuminated entry system is not activated. The multi-meter amperage reading may remain high for up to three minutes, or may not give any reading at all while set in the highest amperage scale, depending upon the electrical equipment in the vehicle. The multi-meter leads must be securely clamped to the battery negative cable terminal clamp and the battery negative terminal post. If continuity between the battery negative terminal post and the negative cable terminal clamp is lost during any part of the IOD test, the electronic timer function will be activated and all of the tests will have to be repeated. 5. After about three minutes, the high-amperage IOD reading on the multi-meter should become very low or nonexistent, depending upon the electrical equipment in the vehicle. If the amperage reading remains high, remove and replace each fuse in the Power Distribution Center (PDC) , one at a time until the amperage reading becomes very low, or nonexistent. (Refer to 04 - Vehicle Quick Reference/Fuse Locations and Types - Specifications) for the appropriate wiring information for complete PDC and TIPM fuse, circuit breaker, and circuit identification. This will isolate each circuit and identify the circuit that is the source of the high-amperage IOD. If the amperage reading remains high after removing and replacing each fuse and circuit breaker, disconnect the wire harness from the generator. If the amperage reading now becomes very low or nonexistent, diagnose and repair the Charging System as necessary. After the high-amperage IOD has been corrected, switch the multi-meter to progressively lower amperage scales and, if necessary, repeat the fuse and circuit breaker remove-and-replace process to identify and correct all sources of excessive IOD. It is now safe to select the lowest milliampere scale of the multi-meter to check the low-amperage IOD.
CAUTION: Do not open any doors, or turn on any electrical accessories with the lowest milliampere scale selected, or the multi-meter may be damaged.

6. Observe the multi-meter reading. The low-amperage IOD should not exceed thirty-five milliamperes (0.035 ampere). If the current draw exceeds thirty-five milliamperes, isolate each circuit using the fuse and circuit breaker remove-and-replace process in Step #5 . The multi-meter reading will drop to within the acceptable limit when the source of the excessive current draw is disconnected. Repair this circuit as required; whether a wiring short, incorrect switch adjustment, or an inoperative component is the cause.

Posted on Jul 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What fuses under the hood affect the radio in a 2006 Pontiac grand Prix?


Bradley, Radio fuse on interior fuse panel marked Radio/Amp is the only fuse I can find in your manual pg. 5-113. This is not to say the radio could be possibly tied into another circuit, so if you can test/probe all the fuses with a test light or DVOM and verify they are all OK and you can also check for power at the radio plug to verify weather it is getting power to radio.
Check the attached link manual. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://www.vadengmpp.com/owners-manual/pontiac/2006-Pontiac-GrandPrix.pdf
How to Test and Replace Car Fuse Like Pro
Checking Fuses Using test light

Aug 27, 2016 | 2006 Pontiac Grand Prix

1 Answer

Where can I get a diagram of the fuse box?


http://www.reliable-store.com/products/2006-ford-taurus-workshop-repair-service-manual-pdf-download

Jan 04, 2016 | 2006 Ford Taurus

1 Answer

Have a 2006 Silverado and radio won't work and have no manual. Which fuse in the door is for the radio, and are there any other fuses that could cause my radio to not work?


The radio fuse is located in the engine compartment fuse box, not the one on the end of the driver's dash. It's a 15-amp (blue) fuse and is labeled "radio". That's the only fuse that supplies power to the radio in your vehicle.

Jul 15, 2015 | Cars & Trucks

1 Answer

Where is the fuse for signal lights on 2006 ford tauras


Go here to access the owners manual the fuse diagrams are in the manual.

Oct 16, 2012 | 2006 Ford Taurus

1 Answer

Need to know what fuse to check for the stereo in a 2005 chevrolet colorado


I'm goona try and hope for your sake that I am correct. The Colorado came out in 2004 until present. There were no changes other then some extras added on. Even the lengths stayed the same. No change. I have an owners manual for a 2006 so I'm guessing it's going to be the same. I am sure that the way the fuse is labeled will be the same (RDO) so I know that will help you out at least. Anyhow, the fuse for the radio is located in the engine compartment fuse box (see picture below) The fuse for the radio (in the 2006) is located in the RDO position. Kind of hard to see but it is on the bottom row (see diagram of layout below). I hope they are the same and I hope this helps you out. good luck.


clifford224_301.gif

clifford224_302.gif

Apr 28, 2011 | 2005 Chevrolet Colorado

1 Answer

2006 toyota corolla eel body style. Radio & clock just quit working. Where is the fuse box & how do i know which fuse it will be.


On the left side of the dash is a small access door for the fuse panel. Look for fuse labeled CIG, it is a 15A fuse.

Feb 22, 2011 | 2006 Toyota Corolla

1 Answer

Where is the fuse for cigarette lighter ??


on the inside fuse panel, in your owners manual it more than likley will be labeled under courtesy lights, which run your radio interior lights, dash lights, and your cigarette lighter

Feb 08, 2011 | 1999 Ford Taurus

1 Answer

Which fuse do I replace for the display/radio screen


There are 2 locations it could be:
- The first is under the glove box cover.There are several mini fuses in there.The next place to look is under the hood.There is a large fuse box on the passenger side by the alternator. The fuses are labeled in the cover.
- The last place is right by the battery, there is also a fuse box which is labeled.

Maybe, you need review this documents:
- 2006 Nissan Murano Owners Manual / PDF
* Display Screen: Section 4-44 / Page 156
* Fuses: Section 8-21 / Page 280

Good luck, and remember rated the help.


Aug 14, 2009 | 2006 Nissan Murano

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...