2006 Toyota RAV4 Logo

Related Topics:

A
Anonymous Posted on Feb 20, 2016

2006 RAV4 won't start and display reads check 4wd system what does this mean?

5 Related Answers

sman1950

  • 119 Answers
  • Posted on Feb 12, 2010

SOURCE: 2008 rav4, the check light, VSC and 4wd lights all on

when the check engine light comes on,the computer system has picked up a problem. the other lights come on because their systems turn off when the computer finds a fault. once the computer problem is repaired,the other lights should go out.

Ad

Anonymous

  • 2 Answers
  • Posted on Mar 09, 2010

SOURCE: 2006 Toyota RAV4, 3.5L V6 Check engine

I am having a multiple cylinder misfire on my 2006 Toyota RAV4 with the 3.5L V6. Every cylinder is reporting a mifire. Each cylinder has it's own coil. I highly doubt that all 6 coils went bad at once. Does anyone have any idea what my be causing this?? Is that the problem you two are having?

Anonymous

  • 4793 Answers
  • Posted on Mar 09, 2010

SOURCE: toyota Rav4 D4D 2006,warning lights check

okay.how would the injectors have anything to do with the vehicle stability control/4wd.??if it were injectors at such a low mileage you would feel a real lack of power.now as toyota own diahatsu you could save yourself a fortune if you ask them to diagnose a fault!!to check vsc is working put car in 2nd and floor the pedal turning as tight a circle you can brave.it should stop the inside wheels from screaming....to check 4wd do the same and you will feel the car trying to pull itself apart.you will see what i mean.!!!

Anonymous

  • 1672 Answers
  • Posted on Dec 10, 2010

SOURCE: 2006 Rav4 sport 3.5 4wd (if

Hi,
There is transmission filter cartridge that you should replace whenever you change the fluid. Located in your transmission.
Hope that helps you out!

Thanks for using Fixya!

Anonymous

  • 242 Answers
  • Posted on Jan 25, 2011

SOURCE: The vsc, 4wd, airbag light

It is a possibility that that you need a speed sensor, or a battery somebody with a good scanner has to check for engine,abs,airbag codes. If the mechanic that is scanning your vehicle is not familiar with toyota found multiple codes en different systems the problem is the battery.
If the problem-is a speed sensor code, then there is service bulletins that advice you to replace hubs and wires, that is really spensive but necessary. Water intrusion is the problem, creates corrosion that spays in the sensor and wire, if you replace only one the other transfer corrosion to the new item. Good look Nikky.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

4WD indicator is permanently displayed on the dashboard

This indicates that a problem exists in the control system of the 4WD system. This can be mechanical like a sticking clutch in the transfer case or electrical in nature. You need to have the dealer do special testing to determine what is the actual cause. If you have never changed the fluid in the transfer case do that and see if the light is mechanical in nature from dirty fluid and a sticky cone clutch
0helpful
1answer

My 2006 Jeep commander seems to be stuck in 4wd.. when i drove it last night it was just fine. got up this morning for work and its stuck.. dash displays service 4wd system...any help on what could have...

we dont know what 4wd option you have , so how can we answer you. Impossible that be.

part time 4wd PT
or full time. awd
do not drive part time, on non icing pavement, are you on dirt?
not posting road conditions also makes all answers wrong.
if you attempt to use PT or lock on dry pavement you will damage the car.
ever read the operators guide yet>?

what does stuck mean
car stuck
lever stuck
just light stuck, and drives ok
is steering acting odd , like it does in 4low, or PT ?
2helpful
1answer

2006 Rav4 sport 3.5 4wd (if you can call it 4x4) My wife's rav4 has blackish trans fluid .. is there anything tricky that i need to know about before I start to change it? our service guys at...

Hi,
There is transmission filter cartridge that you should replace whenever you change the fluid. Located in your transmission.
Hope that helps you out!

Thanks for using Fixya!
24helpful
2answers

Rav 2006, check engine light, VSC light and 4 wheel light came on, whats up

pls check the gas or fuel cap gor if closed , if yes , pls open it and close it again but carfully to hear only one clik as mentioned on the top of this cap, then check engine and vsc and 4wd lights will be turned off when you'll turn on your vehicule. pls let me know if it work .
1helpful
1answer

Oil change light.

On my 06, Set the display to Trip A and turn key to OFF. Hold the Trip reset down and turn key to ON (do not start RAV4). Wait about 5 sec until it displays 00000. Turn key to OFF and it should be reset.
0helpful
1answer

Toyota Rav4 D4D 2006,warning lights check engine,vsc,4wd system fault displayed. Took to dealer for diagnostic check ,error code p1238 injectors they said. quoted me £2100 to replace all units. only 2...

okay.how would the injectors have anything to do with the vehicle stability control/4wd.??if it were injectors at such a low mileage you would feel a real lack of power.now as toyota own diahatsu you could save yourself a fortune if you ask them to diagnose a fault!!to check vsc is working put car in 2nd and floor the pedal turning as tight a circle you can brave.it should stop the inside wheels from screaming....to check 4wd do the same and you will feel the car trying to pull itself apart.you will see what i mean.!!!
0helpful
1answer

When i started my 2006 rav 4 this morning these lights came on and are still on, brake light,4wd light, ABS, VSC LIGHT?

If you had your foot on the brake while starting brake light could come on. If a catalytic convertor does not pass at startup (possibly ox sensor or whole convertor) then the computor turns 4wd vsc and check engine light on. note the six cylinder has three catalytic convertors and the four cylinder has two. Very expensive if convertor(s)
4helpful
2answers

How do you put rav 4 into 4 wheel drive

I have a 2006 rav4....there is a button to the left side of the radio labeled 4WD push it and 4WD light comes on on dash. It is electronic. Bad thing is that it automatically turns off the 4WD when the car reaches about 25 MPH....This means that if you want to sling mud while going through a puddle at 10MPH while reading 40MPH on speedometer...you are out of luck.
0helpful
1answer

Since 4WD is always on, why would the 4WD indicator light come on? Does this mean there is a problem? I was driving in the rain yesterday, and the 4WD, engine, and VSC lights came on all at once. At first...

Read the users manual, it should go off after the engine starts, if it stays on there is a problem, you will have to take the car to the service to check out.
21helpful
2answers

2006 Toyota RAV4, 3.5L V6 Check engine

I am having a multiple cylinder misfire on my 2006 Toyota RAV4 with the 3.5L V6. Every cylinder is reporting a mifire. Each cylinder has it's own coil. I highly doubt that all 6 coils went bad at once. Does anyone have any idea what my be causing this?? Is that the problem you two are having?
Not finding what you are looking for?

548 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...