The Fob key is sensitive to the touch to open car doors
DODGE JOURNEY SERVICE REPAIR MANUAL 2009 2010 DOWNLOAD
for better result of your problem visit this link
SOURCE: key lock on drivers door won't unlock the door
you need to take the door panel off, there is a rod in there that connects to the lock cylinder it frequently pops off, there is a little plastic clip that should hold it on to the cylinder it may be broken!!
SOURCE: 2008 Dodge Grand Caravan side door does not automatically close.
sounds like the door sensor switch is malfunctioning and when almost closed it reacts like it is blocked (such and kid in way) and opens for safety. try flushing trach with hose and try again, if not u need a good repair manual such as chiltons($25 most parts stores ) or see mechanic
SOURCE: On my 2004 Durango I can unlock/open using my
Sounds like the key has lost its programming, or the transponder chip in it has gone bad.
I think you need two good keys to program a third.
Might have to check dealer or do a bit of research online for the full answer.
SOURCE: 2007 Dodge Caravan (35,000 miles) Passenger
The entire system is computer controlled. There is a driver's door module, a sliding door module, a remote keyless entry module, and a body control module all involved in the symptoms you have described. The only advise I have for you is to have all your modules scanned for fault codes. There is most likely a communications fault between the modules. They all have to talk to each other for everything to work.
I did do a Technical Service Bulletin search and found nothing that applies to your problem. The diagnosis will have to begin with a complete scan of all your computer modules. It may even turn out to be something as simple as a bad ground circuit. Fault codes may lead you to the cause. When you have it scanned, make sure you have ALL modules scanned. If it is a communications problem, the module that is having problems communicating will not tell on itself. You must get this information from the other modules that it communicates with.
SOURCE: I don't have my key fob and when I opened the
Remove the alarm, its aftermarket this is better the alarm be removed, heres how remove siren alarm, then go underdash youll see a relay connected to the starter signal, jump the relay permanetly and your done for the flashing light cut the sensitivity ground of the alarm
773 views
Usually answered in minutes!
×