SOURCE: Head Bolt Torque for a 2000 Grand Cherokee Laredo 4.0L
the torque is a 4 step process
1 torque all bolts to 22 ft/lbs
2 torque all bolts to 45 ft/lbs
3 recheck all bolts to 45 ft/lbs
4 torque bolts 1 thru 10 to 110 ft/lbs
bolt 11 to 100 ft/lbs
bolts 12 thru 14 to 110 ft/lbs
bolt #1 is the fourth bolt from the front on the passenger side....#2 is the fourth bolt on the drivers side then you continue in a clockwise order
SOURCE: 2002 Pontiac Grand Prix Thermostat
as you face the engine the thermostat bell is on the right (drivers side) Follow the radiatoe hose. Remove the two bolts and raise the bell still attatched to the hose. the thermostat is there with the rubber seal. You can gently pry the thermostat out with a screwdriver or something similar. Put in new thermostat be sure it is the same as the old one, and then replace or change the seal (be sure it is the smae size and thickness as the old one as I got the wrong size from Napa) Then replace the bell, and tighten, but not over tighten. I hope this helps!
SOURCE: head bolt torque spec
Always use new head bolts.
1)tighten to 40ft/lbs
2)back off 1/2 turn
3)tighten back to 40ft/lbs
4)tighten an additional 90 degrees
5)tighten an additional 90 degrees.
SOURCE: need torque specs for brake caliper bracket bolts.
Hello and welcome. here is the torque specs for the bolts.
Caliper Bolts
85 N·m
63 lb ft
Caliper Bracket Bolts
180 N·m
133 lb ft
Caliper Bolts
85 N·m
63 lb ft
Caliper Bracket Bolts
180 N·m
133 lb ft
caliper brake bracket bolts torque to 180 n.m or 133 ft.lbs
142 views
Usually answered in minutes!
×