My 2004 chrysler sebring radio and door locks stopped working after i needed a boost

Dash lights (Gone?) - FSB Forums - FullSizeBronco.com

www.fullsizebronco.com/forum/21.../198643-dash-lights-gone.html

Sep 7, 2011 - Fully rotating the shaft counterclockwise past a notch activates theinterior lights within the vehicles. ... No aftermarket stereo, the dash lights stopped working, and my taillights ... 8 15 Courtesy/Dome/Cargo Lamps, Electric Outside Mirrors, ... 12 20 C.B. Power Door Locks, Electronic Shift Motor 4WD, Power ...

Radio died, remote system not working, door locks will not work ...

www.topix.com > Chrysler Sebring

Aug 13, 2008 - So what all is not working at this time is: Door locks (with remote it only ... My lights on the dash dim some times and if I hit a bump the radio goes off, ... All the fuses are good, but still no power to the radio, interior lights, push ...

2009 Chrysler Town and Country No Dash instrument cluster lights ...

forum.chryslerminivan.net/.../55281-2009-Chrysler-Town-and-Country-...

Jan 13, 2014 - 10 posts - ‎5 authors

Try unconnect battery for 10 min and reconnect.
Try unlock door, lock door, unlock door, lock door, unlock door. Try starting car.

Check what circuits are connected around this fuse, then check each one, test voltage and wire connections.

Good luck.

I had the exact same problem. It was #5. The fuse with the black thing. It's like a hinge that opens to get the fuse out. Replaced it and got back power to the trunk, radio, mirrors and dome light.

It's definitely a fuse. I would change out the radio fuse and the fuse that controls your door locks. Fuses don't have to be split to stop working.

Hello! Check fuse #11 (15A)...Are your Mirrors and Wipers working? If that fuse is good and mirrors/wipers with dome, door locks and radio are not working it looks very much like a defective Ignition switch...send a comment...

Guru...Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Apparently. . .

its in the inside door frame when you open the back car you will see a small black switch that you can push up or down and it is usually labeled

Check around the MAP sensor area for any connections that may have been disturbed while you were replacing the sensor. Most or all of those functions are controlled by the body control module. I would think that a fault like that would show on the scanner readouts.

me too! - looking at fuse #5 red 10 Amp one but has black thing on it.

Can't get if off..

Have read the manual is wrong and to use panel on side of fuse box for fuse locations...