Tracy, May be a 4x4 actuator problem, you may have to take it into a good transmission shop.Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
1995 4runner will not engage into 4wd
Is this the actuator for 4WD my 4WD won engage
EBay 1995 TOYOTA LAND CRUISER REPAIR MANUAL
SOURCE: 1995 toyota land cruiser
Your front "ball & socket" joints are in dire need of lubrication. You need to do this:
Take the tires off, and look for a fill plug behind the hub, on the housing, above the ball & socket. Remove the plug, and fill it up with 80-90 gear oil. Replace the plug, do the other side.
What you have is a dry joint, and the clicking noise is coming from the u-joint (actually called a "Rzeppa" joint), inside the ball/socket/hub...a good lubrication will eliminate your condition. Hope this answers your question, please feel free to comment back with any other questions...And, thanks for choosing FixYa.
SOURCE: Need tire size for 1995 Toyota Land Cruiser Prado
Big tires:
1. Hard time for your drive train (clutch, cv joint, tranny, diff gears) , power steering, brakes
2. Slow acceleration
3. possible fender damage
4. turning radius problem
5. increase body roll and instability
Advantages:
1. good ground clearance
2. softer ride
3. Enhanced off-road ability
tires your planning to buy can fit into your existing rims.
My personal opinion is for you to go for the bigger tires!
SOURCE: wheel alingment specs for toyota land cruiser
Camber
Left−right error
1°00’ ± 45'
Caster
Left−right error
3°00’ ± 1°
Steering axis inclination 13°00’ ± 45’
Camber, caster and steering axis inclination are not adjustable.
If measurements are not within the specification, inspect the
suspension parts for damaged and/or worn out parts and replace
them as necessary.
INSPECT TOE−IN
Toe−in
(0.08 ± 0.08 in.
This is the only Land Cruiser Specs I could find, hope it helps
SOURCE: Need wheel alignment specs for Toyota Land Cruiser 200
Well your Caster should be +2.0degrees to +4.0degrees Your Camber should be at .+2 degrees to +1.7 degrees but I would keep it around .+2 degrees for best tire wear.Your should be should be 1/16th to 1/8th inch toed in.
SOURCE: i have an 800 amp battery for my 1995 land
Hi: The Specs on a Battery Range From 600 Cold Cranking Amps to 750 Cold Cranking Amps. So if you have a 800 Cold Cranking Amp Battery installed then you are at or Above The Required Amperage Needed.Unless your Running Extra Lighting or Accessories. and you have to consider your Alternator Out-put as well.You need a Alternator that will Keep up the Charge on Your Battery. So in a Nut Shell the More Add Ons you Have the More and The Harder your Alternator has to Work to Try and Keep Your Battery at a Full Charge . A Fully Charged Battery you'll have 2.1 Volts per Cell = 12.6 . Hope this has helped you, Please Let me know how I've Solved your Problem with my Solution. Thanks and Good Luck From d_hubbs
71 views
Usually answered in minutes!
×