Upper ball joint torque specs 2002 explorer xls 4x4 4.0L v6 gas

https://eautorepair.net/Marketing/Default.asp


RTM
read the manual , we just log in and read.

Question edited for clarity

Not easy to get to or change according to this.

https://www.justanswer.com/mitsubishi/5693h-crankshaft-position-sensor-located-2003-montero-is-diagram.html

More
https://www.google.com/search?q=2002+montero+sport+xls+2wd+3.5+v6+crankshaft+sensor+location

..

Looking at the factory repair manual it shows the ball joints themselves are pressed in. If you purchased an aftermarket component that bolts in I would contact that company and ask what the torque specs are supposed to be. If you are referring to the ball joint STUD nut, they are torqued in two passes. The upper ball joint to 37 Lb Ft on first pass and then final pass torque 90-110 degrees. Lower ball joint 37 Lb Ft and 125-135 degrees. See attached screenshots from manual.

Chevy Truck Front and Rear Suspension Specifications Fastener Torque...

Douglas, If upper ball joint is held with castle nut torque is 90 lb-ft. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."




How To Install Upper Control Arm and Ball Joint 2002 05 Ford Explorer...

Hi Robert,here's a link on your upper ball joint repair guide,also join their site,become a member,it's free,then you can use all their repair guides like me. Repair Guides Front Suspension Upper Ball Joints AutoZone com

What is theTorque on front ball joints 2005 Toyota sequoia ...

www.fixya.com/cars/t25021879-thetorque_front_ball_joints_2005_toyotaAug 28, 2014 - Tightening specs for castle nuts - Toyota 2005 Sequoia question. ...There are no torque specs for the upper or the lower ball joints on any of

yes

If the boots are ripped on your lower ball joints you will need to replace them, rain water has washed away the factory lubricant they have no grease fitting from the factory. Replacements will come with grease fittings. Tie rod ends can also be the source of the noise, same deal no factory fittings. VERY COMMON PROBLEM.

the lower ball joints have to be pressed into the lower control arms.The upper ball joints are part of the upper control arm so the upper control arms have to be replaced