2008 Buick Lucerne CXL Logo

Related Topics:

Bonita Guidon Posted on Apr 04, 2016
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

N0 p0wer to fuel pump - 2008 Buick Lucerne CXL

1 Answer

jack layton

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Buick Master 5,569 Answers
  • Posted on Apr 04, 2016
jack layton
Buick Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Nov 12, 2014
Answers
5569
Questions
0
Helped
2397326
Points
20059

I have to ask. How long since a tune-up? Are there any applicable trouble codes?
With engine cranking, if no spark at the spark plugs and no fuel injector pulse along with no fuel pump action, have to check rpm signal.
If you have spark and fuel injector pulse but, no fuel pump action, then we check the fuel pump circuit. Did you check applicable fuse, not only check the fuse, check the fuse circuit for voltage. At the fuel pump connector, gray wire is voltage for fuel pump motor and black wire is ground.
n0 p0wer to fuel pump - 26152388-udu0z3pubqm1mxirajgq5k30-3-0.jpg

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Toyota dyna No4c p0wer loss on accelerting the speed of engine is limited till 2000rpm

run the fault codes and look for a sensor that has activated the rpm limiter
0helpful
1answer

Hi, how do I bleed the fuel system on a vw microbus 1997 model 2.5iand how do I know if my timing is correctly set I,

fuel pump working?
injectors spray?
put some fuel 3 spoons in the air inlet and crank the engine
should start for couple of seconds the ignition is ok.
good luck
0helpful
1answer
0helpful
1answer

HWhat's your problehm? headlights wont work

Run a wire from the ground lead on the headlight socket to the battery negative post, and see if that works. If you got 12v to the light and it isn't working, it almost has to be the ground.
1helpful
1answer

2002 4.3 eng blazer, its hard to start .n0 check eng. light ?

The problem is your Fuel Pressure Regulator. this is really common on newer cars to go out.here is the way you can check to see if that is the problem. Locat the fuel rail on the engine. find the little round valve looking thing on the fuel rail that looks like it has a vacume line hooked to it. This is the Fuel Pressure Regulator. All you have to check it is pull off the vacume line going to it and if there is any fuel that comes out of the top of the valve or out of the vacume line this is the problem. there should be no fuel comeing out of it or the vacume line. and this will not cause a check engine light to come on. The regulator could run from $50- 130 depending on. Hope this is the Answer you were looking for
2helpful
1answer

I CANT FIND THE POWER STEERING FILL RESEVOIR ON MY 1995 OLDSMOBILE 98, (N0 TURBO)

Welcome to FixYa.com Look to where the drive belts are and you will see a cap black with power steering written on it, Regards, Lee
0helpful
1answer

Mazda rx8 has no p0wer and smells of gas

check your coil packs i have to replace them after about 30,000 miles. its most likley on the leading plug you would hardly notice a trailing plug not firing
21helpful
6answers

1.5 diesel megane injection fault

The cheapest way to go is to change the fuel filters first and the air filter. Then I would change the crankshaft sensor.

You may have to bit the bullet , and have the fuel pump changed before the fuel injection pump. The fuel pump in the tank can be loosing pressure to the fuel injectoin pump.
I think the lesser cost is the fuel tank pump vs. the fuel injection pump.

The system runs of fuel and air. No spark like on a gas engine.

So the problem can only be lack of fuel or lack of air getting into the vehicle air induction. A restriction in fuel or air will make the engine run poorly.

Not finding what you are looking for?

232 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...