Cars & Trucks Logo

Related Topics:

k
keith olson Posted on Apr 22, 2016

Is there a braake light relay for 1991 q-45?

Tail lights and brake lights all work, but dashboard display say brake light is inoperable. have changed all tail and brake light bulbs,checked fuses under dash.

5 Related Answers

Anonymous

  • 1263 Answers
  • Posted on Sep 01, 2008

SOURCE: Dashboard and tail lights out on 97" Nissan Sentra

i would check the connectors under the dash they have a tendancy to get loose are get hot and short a fuse this is most likely the problem...please rate this....

Ad

Anonymous

  • 1990 Answers
  • Posted on Feb 05, 2009

SOURCE: Left rear brake light stopped working but bulb and fuses are OK.

These are Dual Function Bulbs. They control the Parking Lights and the Brake Lights. This Bulb is Burnt out on the Brake Coil inside the Bulb. I have actually seen Bulbs that were Bad But you could not Tell by jast looking at them. It should be fine with a New Bulb. Please Rate My Response! Thanks!

Nicholas Csorba Jr.

  • 148 Answers
  • Posted on Feb 17, 2009

SOURCE: Tail lights don't work on 1998 Chevy Silverado.

check the wiring from the tailights back to the fuse panel, it sounds like an open connection. if i recall correctly check under the dash on the drivers side near the fuse panel for a bunch of wires in a bundle and look carefully for a wire or two that are cut/shorted/or seperated, you can also check under the drivers side kick panel by the hood release.

Anonymous

  • 1 Answer
  • Posted on Mar 04, 2009

SOURCE: Tail lights / Brake lights

i was having a similar problem with my 2000 SL. when the taillights would go, so would the cruise control. and through many bulb and fuse replacements, i finally went into a saturn dealership and they did a recall campaign on it. they did their thing and i havnt had any problems since. FREE!

johnjohn2

Johnny Brown

  • 5763 Answers
  • Posted on May 27, 2010

SOURCE: brake lights don't work

This sounds like a bad brake light switch, this switch is located on the bracket that holds brake pedal,you can test for power at switch,also if you remove connector and jump terminals with a wire and see if lights lite, if lights light then switch is bad,

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do i troubleshoot 2004 Nissa Sentra tail lights not working

check the globes as filament for tail light it could be blown
while the filament for the brake light usually in the same globe
could be ok

check fuse 36 tail light fuse may be under bonnet in relay box
check relay for tail light
is relay switch getting 12v from the cpu device that controls tail light
nissan-undefined-undefined-0.jpg check on relay pin tabs
0helpful
1answer

Hi may i know how to fix the dashboard panel no backlight and headlight not switch off warning beep sound of Proton Saga BLM 1.3 Kindly advice and Thank you

Dashboard backlight works together with the tail light. Both the headlight and tail light is controlled by relays. Check the engine bay fusebox. Look at the inside of the fusebox cover and you can see the 'location map'of relays and fuses. Theheadlight and tail light relays sits side-by-side. Change both and check for blown hedlight fuses..
0helpful
1answer

Headlight switch relays

Headlight switch probably the problem. One circuit is shutting off when the other turns on. If it was a fuse or relay, it would just turn off...
6helpful
1answer

Dashboard warning light......Orange car symbol with what looks like rear light beams coming from the the back......Warning light is top left on the dashboard display

if its on when the brake isn't being depressed its a tail light bulb has blown out, if its on when you apply the brakes , its a brake light bulb
0helpful
1answer

Aftermarket LED stop/tail lights prevent cruise control working. Seems the cruise has a logic input, normally held low by brake light cct, but with LEDs, it stays high. Only answer without using power...

Too difficult to do this way. Place a diode in each input leg of the stop/tail light cct to prevent back current flow to the effected ccts.I have done this as I had the same problem as my cruise control and traction control where inoperable. These 'high end' features of later model cars disconnect when you brake but in most case insted of a simple on/off brake switch the swich is double thow and it it turns on brake light and turns off other ccts
1helpful
1answer

LAMP OUT DASHBOARD WARNING SIGNAL DISPLAYS UNKNOWN

have someone stand behind ur car and check ur brake lights when u hit the brake and not ur tail lights when u turn all ur lights on. that warning light came on for me and i discovered a brake light out
5helpful
1answer

Dashboard lights and tail lights won't turn on

does your vehicle have tilt wheel...that is a common problem and your brake light wires run down through the steering column
2helpful
2answers

No tail lights or brake lights

Check the relays associated with the tail lights, I believe that the tail light relay and the turn signal relay are two different entities. Hopefully that helps.
Not finding what you are looking for?

23 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...