To replace the starter motor on a vr/vs commodore is pretty straight forward I would recommend you do it by using these steps .
1.Position vehicle on hoist or on safety stands
2.disconnect the battery
3.when under the vehicle on the passanger side rear you will locate the starter motor .
4.remove and disconnect all wiring connected to starter .
5.there are 2-13mm bolts that go through the bottom of the starter into the engine block once these are removed you will be able to wiggle and work the starter out
follow these steps in reverse and it will all workout .
6.position starter motor in location
7.start the bolts to hold starter in position.
8.connect and securer wiring to starter .
9.finish tightening bolts up in starter.
10.connect battery
all is good finished
I suggest you pose the question on the VS section of the Just Commodores Forum and one of the guys there should be able to help you with that.
Here is the link to the website........................
Forum VR VS Holden Commodore 1993 1997
======================================================
1,809 views
Usually answered in minutes!
×