SOURCE: Camshaft sensor location
The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.
SOURCE: need help finding camshaft position sensor
2.0L 2.4L Removal
The camshaft position sensor is mounted to the rear of the cylinder head.
Remove the negative battery cable.
Disconnect the PCV hose and reposition
Disconnect electrical connectors from the camshaft position sensor.
Remove camshaft position sensor mounting screws.
Remove sensor.Loosen screw attaching target magnet to rear of camshaft and remove magnet.
Instalation
The target magnet has locating dowels that fit into machined locating holes in the end of the camshaft.
- Install target magnet in end of camshaft. Tighten mounting screw to 3 Nm (30 in. lbs.) torque. Over torqueing could cause cracks in magnet. If magnet cracks replace it.
- Install camshaft position sensor. Tighten sensor mounting screws to 12.9 Nm (115 in. lbs.) torque.
- Carefully attach electrical connector to camshaft position sensor. Installation at an angle may damage the sensor pins.
- Connect the PCV Valve hose.
- Connect the negative battery cable.
2.7L V6 Removal
The camshaft position sensor is mounted in the front of the head.
Disconnect electrical connector from sensor.
Remove camshaft position sensor screw.
CAM Sensor Location 2.7L
Without pulling on the connector, pull the sensor out of the chain case cover.
Installation
- Install sensor in the chain case cover and push sensor in until contact is made with the boss on the head. While holding the sensor in this position,install and tighten the retaining bolt to 12 Nm (105 in. lbs.) torque.
- Attach electrical connector to sensor.
Good luck and hope this helps
SOURCE: where is the camshaft position sensor located on a
the camshaft sensor is mounted on the camshaft housing located on the end of the cylinder head.
SOURCE: P0340 Camshaft Position Sensor. How do I fix it?
http://www.youtube.com/watch?v=ve1XW5Ul8Os
please go the above link and you have a video procedure for how to change the sensor.
just do it and you are done to drive your car away.
SOURCE: 2001 dodge ram 1500 5.9 camshaft position sensor
CAMSHAFT POSITION SENSOR
2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl
The Camshaft Position Sensor is located:
Under hood, center, upper engine area, rear of intake manifold, mounted in distributor
If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants
800 views
Usually answered in minutes!
×