How do i clear the abs code. brakes are all fixed

You are in Limp Mode for safety because it is a braking issue. Fix the code, clear it is operate as normal.

Code C0278 Toyota Open or Short Circuit in ABS Solenoid ...

AutoCodes https://www.autocodes.com > c0278_toyota
What are the Possible Causes of the DTC C0278 Toyota? · Blown Anti-Lock Brake System (ABS) Solenoid Relay Fuse · Faulty ABS Solenoid Relay · ABS Solenoid Relay ...

https://www.google.com/search?q=Toyota+code+CO278

..

As long as your car's brakes work and is safe to drive, take it to any parts store. They have error code readers that can reset these alarms. If they are not able to reset them then you will probably have to take your car to a brake shop for maintenance on your ABS sensors. Traction control is associated with the ABS sensors.

If the ABS light is on, that means there's a trouble code stored in the computer. If you clear the code but don't fix the problem, the light will just come on again. You have to fix the problem

Usually ABS and some Check Engine light codes are "hard codes" which means they cannot be turned off until what set code is fixed.

Three things will throw the code
1. Worn shoes (pads)
2. Bad abs module
3. Air in abs lines

if you've changed your pads recently you probably haven't bled the air from the abs lines

in most cases abs lights will go out after the problem is fixed but you can try to disconnect the battery for a few min

Only the computer can clear history codes . If the problem was fixed in about 100 ignition cycles the computer will clear this codes . Code reader . will it check Codes in the EBCM - electronic brake control module ? ABS DTC'S

you have an ABS code in the ABS computer. You most likely damaged an ABS sensor. even after myouo fix this you will need to get the code cleared
NOTE: autozone wont be able to access the ABS computer.

So is your ABS light on? Computer won't hold a code for the ABS light. There's 4 sensors one at the back of each wheel one of them is bad. As longs as your brakes are working normally you can at your time to fix it. ABS was made for panic stops only thats why the pedal pumps fast when you stop hard.

The code is for the Vehicle Speed Signal (VSS). The VSS is produced by the ABS electronic control unit by averaging wheel speed sensor inputs and sending a digital signal via CAN bus to other modules that use the VSS. To test the ABS, a Volvo-compatible scan tool is necessary. If one is not available, the car should be sent to a Volvo dealer for ABS diagnosis. I can tell you however that most of the cars are fixed by replacing the ABS Control Module.