How to reset airbag light 2006 Mercury Milan and Ford Fusion

SOURCE: where are the headlight adjustment screws on a

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Vincent G

• 2363 Answers
• Posted on Dec 16, 2009

SOURCE: how to reset airbag light on 2008 ford fusion

Here's a quick check list for most common cost of SRS / Air bag problem.


Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat

(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT disconnecting the negative battery connector to clean the code(s)

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate me answer if it is useful to you.


Cheers,

Mustgo

SOURCE: Upgrading 2006 Mercury Milan's sound system with MP3 jack.

Even though your current radio has an AUX button the radio is not programmed to utilize it.
There is no 'easy' way to add the '07 Job 2 and later year model's factory Aux input.
You will need to buy an aftermarket solution. Something like this http://pac-audio.com/productDetails.aspx?ProductId=821&CategoryID=24

SOURCE: I need to replace the driver side door handle to

remove door panel. put window all the way up first. with the door panel removed, see if you can get to the clips holding the door handle to the door, it may have nuts and not clips.look at the replacement to sort of get an idea of how it's held in place. if you can't get it because the window is in the way, then it also needs to be removed to avoid breaking it. now, the door lock lever and switch lever are going to be connected to the handle. just pop off the plastic clips and remove so you can get to the door handle. it's a bit tedious but it's doable.

SOURCE: 2006 Ford Fusion SE: gear

it is more then likley a fuse under your dash on the drivers side .