Need to locate the camshaft sensor for 2007 ford 500 awd v-6,my car only goes 45miles an hour.

Question edited for clarity, and add maker.
Question moved to model category.

Videos showing location and replacing.

https://www.google.com/search?q=2007+Toyota+Sienna+camshaft+position+sensor+location

You don't need a part number, you just buy by 'year make model'. Don't go cheap on sensors, make sure they are Denso OEM quality and not made in China or Mexico.

https://www.google.com/search?q=2007+Toyota+Sienna+camshaft+position+sensor

The part number is shown in this one. Don't forget there is one on each bank. Your scan tool computer should tell you which one is faulty.

https://partsavatar.ca/2007-2016-toyota-sienna-cam-position-sensor-denso-196-1001?gclid=Cj0KCQiA-oqdBhDfARIsAO0TrGGmtSNhZJQloGCMTlp_jYy7SDfFTw4VFJ9d5dhSQm08-Z4xxykiR3YaAkugEALw_wcB

..

check out the video in the link

https://www.google.com/search?q=2007+Ford+500-+where+is+the+fuel+pressure+sensor+location

..

(1) Camshaft Position (CMP) Actuator Solenoid - Intake Bank 1
(2) Camshaft Position (CMP) Sensor - Intake Bank 1
(3) Camshaft Position (CMP) Sensor - Intake Bank 2
(4) Camshaft Position (CMP) Actuator Solenoid - Intake Bank 2
(5) Camshaft Position (CMP) Actuator Solenoid - Exhaust Bank 2
(6) Camshaft Position (CMP) Sensor - Exhaust Bank 2
(7) Generator
(8) A/C Compressor Clutch
(9) Camshaft Position (CMP) Actuator Solenoid - Exhaust Bank 1
(10) Camshaft Position (CMP) Sensor - Exhaust Bank 1

If that the ac compressor with the belt on it. Maybe the picture will give you some orientation?

the camshaft position sensor is on top of the valve cover, if you are in front of the car its on the right side on the end,now that if its a four cylinder on the 3.0 its on the left bank standing facing the engine it would be near the engine mount

There are some GREAT pictures I think will help you find it. Go to http://www.ford-trucks.com/forums/1160636-camshaft-position-sensor-cmp-wiring-pigtail-replacement.html It is located under the subject of "Camshaft Position Sensor (CMP) wiring pigtail replacement"

Fix your car right away, by clicking the link FORD FIVE HUNDRED 500 SERVICE REPAIR MANUAL 2005 2007 DOWNLOAD

The brake pedal sensor on a 2007 Ford Edge AWD is mounted on the brake pedal bracket, where the brake switch is also located.
hope it can help you and if you need a diagnostic tool you can click here: chinasinoy.com

It should be located in the valve cover, towards driverside.

Hello,

To find the crankshaft sensor remove the fan assy from the radiator and the exhaust manafold heat shield then just below to the right end of the manafold you will find the wire to the sensor. To remove it you will need a #30 Torx tool. The camshaft sensor is located almost straight above at the end of the cam.

Take care.