SOURCE: 1992 ford ranger 3.0
i was once pulling a trailer with a ranger when it suddenly lost power and the engine died. turns out the problem was with the fuel shut off inertia switch. the switch is supposed to activate in case of accident. on my model the inertia switch is located in the passenger side under the glove box. dont know where yours is located. once you find it, just push the button and see if it resets. good luck.
SOURCE: ford ranger will not start
check your crankshaft sensor to see that its not got a broken wire
SOURCE: 1992 Ford Ranger XLT V6 wont start without ether
first go to an auto partstore and have the code checked. most do it for free. could be coil, fuel pump, fuel filter, air filter or even a bad gas cap. but the dianogstic test should pin point the problem.
SOURCE: 1996 Ford Ranger won't start
I had the same problem , and if you read your book, it could be the fuel pump shut off switch, mine was bad and went from on to off position, its usually under the passenger side of the dash, look underneath at the "top" of the carpet, and you'll see a little red switch, check to see if the thing is plugged in , if it is , check to see if the switch is all the way down. i had to get a new one , sombody must have kicked mine and made it broken, but i got a new one and it worked fine
SOURCE: 1992 Ranger: where is the starter on a 92 ford ranger...
if it is 5sd it is on the drivers side by the oil filter and it would have three bolts
203 views
Usually answered in minutes!
×