Wiring diagram for 3.0 litre xLT supercab
SOURCE: 1993 ford ranger supercab
the fuse box is inside the pickup under the drivers side dash, there is a flasher which is the round one in the fuse box, it controls turn signals and emergency flashers also in the same fuse box, there is a 15 amp fuse which controls just the turn signals it sits vertical instead of horizontal.
SOURCE: Wiring Diagram for 1999 Ford Ranger 3.0
if u can gain access to the ignition switch wiring use a testlight and probe each wire while turning the ignition at start position.one of these wires shld have power during starting position and release it again to confirm.this wire goes directly to the trasmission multi lever position swicht (mlp).this MLP is mounted just outside the transmission shifting lever ganged together.Trace the corresponding return wire using the testlight. You may need someone to help you do the job.The return wire usually go to a relay on your fuse box on the engine compartment.Then from relay to the starter.
SOURCE: Wiring Diagram for 2005 Ford Ranger XLT
I have wiring diagram. Respond with your email address or fax number and I will sent it to you.
SOURCE: need wiring diagram for a 2001 ford ranger xlt 3.0
Hi there, Is this diagram address your request?
SOURCE: 1998 ford ranger xlt 2.5
These are not very good but all I could find. The cam mark is about the 7 o'clock position. I cannot see the crankshaft marks in the side pic.
855 views
Usually answered in minutes!
×