Proton jumbuck emission stays on

SOURCE: proton jumbuck electrical fault on

I had a similar problem with my jumbuck,2 sets of keys only one worked. Replaced battery now ok.CR2032 ,tednanango

SOURCE: hi hope you can help i have a proton jumbuck and

it is possible that you have a blown fuse, HIGH & LOW beams are usually on different fuses, most likely for safety reasons so as if either one blows at least you still have lights, check the fuses in the fuse box......hope this helps......cheers.

SOURCE: Proton Jumbuck Hazard Indicator lights not working.

may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: diyobd2.fr

SOURCE: Hi after my proton jumbuck turns over and runs there is a surge noise for about a second coming from the engine bay then goes away...this happens every time it starts but after a long run its fine unt

check to see if you have a viscous fan hub connected to the fan. It so it is the hub working correctly.

SOURCE: My car runs fine until warm but when aircon is turned on my car and steering wheel vibrates and revs drop to 0.7-0.500 revs?it is a 2003 proton jumbuck with 148k on it.

Probably a bad bearing on the A/C compressor. Replace the compressor. Bearing is on the inside, not the pulley bearing.