If not fuses
they are two different systems
dash lights have a switch
cruise control could be the cruze switch itself or
a electronic cruze system or vacuum faulty units can be replaced
SOURCE: Cruise control does not work
On my 05 Wrangler Unlt'd Ruby - The vacuum hose on the drivers side of engine had come off, which disengaged my Cruise and the actuator which determines whether my heater points to the vent, Defrost or feet. Put it back on and secure with a cable tie.
If it is like mine, you will then have idling problems, especially when coming to a stop. You will need to clean the throttle body because the engine has picked up **** through the open port while it was off. Directions for that exist on this site elsewhere.
All of these are easy - i hadn't worked on a car in >25 years and it took me 30 min.
SOURCE: 1998 plymouth grand voyager cruise control relay/fuse location?
Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.
SOURCE: the cruise control dont work in my 2003 jeep liberty
Same problem here - turned out to be the Vacuum line from the left rear of the engine on the firewall up to the right side of the throttle body ? air intake.
Plugged it back on the hose connector - problem solved.. Works perfect again..
SOURCE: Fuse location for Dashboard light in 1998 Nissan
Fuse Number 39 10amp fuse Color Red.
Fuse Number 11 10amp fuse Color Red
This illuminated your dash (cluster)
Let me know if this help you.
Check with test light.
SOURCE: 2007 GMC Yukon Cruise Control
Check the speed sensor. Look up the location at autozone .com or google. It is either near the tranny or at the passenger side wheel. The speed sensor is almost always connected to cruise control problems.
318 views
Usually answered in minutes!
×