Question about 2004 Pontiac Bonneville

1 Answer

Do you access the blower motor on an 04 bonneville from under the hood or passenger side behind the glove box?

Posted by on

  • Jim Wiley
    Jim Wiley Sep 11, 2016

    Thanks! I replaced the blower and repaired the corroded wires to fix the 3 windows and locks not working. Very productive day! Now I can focus on the little things!

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Pontiac Master
  • 15,575 Answers

Passenger side under the glove box ,
Remove the right side sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.
Disconnect the electrical connector (1) from the blower motor.
Disconnect the blower ventilation tube (2) from the module.
Remove the blower motor screws (3).
Remove the blower motor from the housing.
Instrument Panel Insulator Panel Replacement - Right Side
Removal Procedure
Remove the fasteners at the rear edge of the insulators in order to disengage from the lower instrument panel.
Pry out the retainers in order to release.
Turn the heater temperature sensor 1/4 turn in order to release and allow to remain connected to its wire (CJ2 vehicles only).
Disconnect the electrical connectors.
Slide the insulator rearward in order to remove.

Posted on Sep 11, 2016

Ad

4 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

SOURCE: heater blower motor just quit working during heavy rain

The rain had nothing to do with it. What ever GM told you was a quess,unless they worked on it. You never change parts until you know their bad. Have to at least know how to test relay, if you do find it. Stop by dealer,they will come out and remove it for free

Posted on Sep 29, 2009

ZJLimited

ZJ Limited

  • 17970 Answers

SOURCE: where is the blower motor resistor in a 2001 dodge

Caravan, Grand Voyager, Town and Country, Voyager, 2000-2004
Blower Motor - Removal & Installation

  1. Disconnect and isolate the negative battery cable, then wait 2 minutes before proceeding with the removal. This will effectively disable the air bag system preventing possible personal injury.
  2. Remove the glove box from the instrument panel.

    a1b7373.jpg
    Fig. The blower motor is located behind the glovebox, behind the blower motor cover
  3. Remove the A/C-heater blower motor cover.
  4. Disconnect the blower motor wiring connector.
  5. Remove the blower motor wiring grommet and feed the wiring through the blower motor housing.
  6. Remove the blower motor mounting screws.

    bdc6158.jpg
    Fig. Once the cover is removed, unplug the electrical connector and push it through the opening in the housing

    063bc30.jpg

    Fig. The blower motor is secured to the housing with three small screws
  7. Allow the blower motor assembly to drop downward to clear the instrument panel and remove from vehicle.
To install:
  1. Place the blower motor assembly into position on the A/C-heater unit and tighten the mounting screws.
  2. Route the blower motor wiring through the blower motor housing and seat the wiring grommet in the hole of the blower motor housing.
  3. Reconnect the blower motor electrical connector.
  4. Install the A/C-heater blower motor cover.
  5. Install the glove box into the instrument panel.
  6. Reconnect the negative battery cable. Check blower motor operation.


Auxiliary Heater and Air Conditioner
Blower Motor - Removal & Installation
  1. Disconnect and isolate the negative battery cable.
  2. Remove the right quarter trim panel as follows:
    1. Remove first rear seat. Remove the second rear seat, if equipped.
    2. Remove the sliding door sill plate.
    3. Remove the quarter trim bolster.
    4. Remove the upper C-pillar trim and D-pillar trim panel.
    5. Remove the first and second rear seat belt anchors.
    6. Remove the screws securing the quarter trim to quarter panel from the bolster area.
    7. Remove the screws securing the rear edge of the quarter trim to the support bracket.
    8. Carefully disengage the hidden clips securing the front of the quarter trim to the quarter panel just rearward of the sliding door opening.

      1dc958e.jpg
      Fig. Removing the trim panel to access the rear blower motor
    9. Disconnect the wiring harness connector from the accessory power outlet, if equipped.
    10. On long wheelbase wagons only, remove the quarter trim from the quarter panel and pull second rear seat belt through access hole.
    11. Pull first rear seat belt through the access hole.
    12. Remove the quarter trim panel from the vehicle.
  3. Remove the 5 screws mounting the A/C-heater blower motor housing to the rear HVAC unit (one mounting screw located on evaporator cover).
  4. Twist the blower motor out of scroll housing.
  5. Disconnect the blower motor wiring connector.
  6. Remove the blower motor from vehicle.

    1e2cfdc.jpg
    Fig. The rear blower motor is held in place by four screws
To install:
  1. Install the blower motor unit into the vehicle.
  2. Reconnect the blower motor wiring connector.
  3. Secure the blower motor into scroll housing.
  4. Install and tighten the 5 screws mounting the A/C-heater blower motor housing to the rear HVAC unit (one mounting screw located on evaporator cover).
  5. Install the right quarter trim panel as follows:
    1. Install the quarter trim panel in position in the vehicle.
    2. Insert and pull the first rear seat belt through the access hole in quarter trim panel.
    3. On long wheelbase wagons only, insert and pull the second rear seat belt through access hole in quarter trim panel.
    4. Reconnect the wiring harness connector to the accessory power outlet, if equipped.
    5. Engage the hidden clips to secure the front of quarter trim to quarter panel rearward of sliding door opening.
    6. Install the retaining screws that secure the rear edge of quarter trim to support bracket.
    7. Install the retaining screws that secure the quarter trim to the quarter panel in bolster area.
    8. Install the second rear seat belt anchor (if equipped), and the first rear seat belt anchor.
    9. Install the D-pillar trim panel and upper C-pillar trim.
    10. Install the quarter trim bolster.
    11. Install the sliding door sill plate.
    12. Install the second rear seat, if equipped, and install the first rear seat.
  6. Reconnect the negative battery cable. Check blower motor operation.

Hope helps (remember rated this).

Posted on Jul 11, 2010

Claudio Riccio

  • 245 Answers

SOURCE: I have a 2007 Chevy

it is located behind the glove box.

Posted on Jan 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace the blower motor in my 2004 saturn l300


blower motors are normally located under dash on passenger side behind glove box very simple procedure unbolt panel cover locate blower remove bolts and reverse for install in other vehicles under hood on firewall passenger side

Nov 21, 2011 | Cars & Trucks

1 Answer

Fan blower doesnt work


I'd test for power at motor itself, in behind glove box under dash. From there is goes back to blower motor resistor located under the hood behind shock tower on passenger side on firewall, and then back to control at dash. Not uncommon for the resistor to go, and leave you with either just high speed or nothing at all.

Jan 23, 2011 | 1999 Plymouth Voyager

1 Answer

Haeter blower where ius it in a 1997 blazer ls


it's under the hood on the passenger side. It's basically behind your glove box but you access it under the hood. It's covered by a black plastic shroud that says something like "Blower motor service cut here". Hope that helps you.

Dec 18, 2010 | 1997 Chevrolet Blazer

1 Answer

Where is the blower motor located on a 2001 pontiac bonneville


The blower motor is on under passenger side dash below the glove box if it is not working you may want to check the pigtail plug that goes to it.

Nov 14, 2010 | 2001 Pontiac Bonneville

2 Answers

Where is the blower motor located on a 98 Jimmy?


On my 1998 GMC Jimmy it is under the hood on passenger side on firewall behind the PCM (black box) which is mounted on top of coolant overflow bottle. You'll have to remove these two items for better access or at least the PCM. Then you have to cut the moulding on the blower motor housing. You should see a groove already formed all the way around the housing and this is where you have to cut. Just don't cut all the way as you have to reseal it with caulk once you are done installing new motor.

Dec 16, 2009 | 1998 GMC Jimmy

2 Answers

98 gmc Sonoma blower motor and resitor out!


the blower motor itself is under the hood on the firewall.usually passengers side..you may have to take the fan off from the inside.

Sep 20, 2009 | 1998 GMC Sonoma

1 Answer

Wipers


Resistor gone for blower. Not sure where yours would be, can't seem to find info I need. Common locations, in under dash on passenger side near blower motor, under hood on firewall , passenger side under cowl. Behind glove box.

Jan 13, 2009 | 2000 Chevrolet Silverado

Not finding what you are looking for?
2004 Pontiac Bonneville Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...