Question about 2005 Nissan Murano

1 Answer

My Murano back doors will not lock or open at times with or without the the remote

Back door will not lock or unlock at times

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 85,223 Answers

I would think the door lock actuator motors are sticking, they are very lightly built little toys.

Posted on Sep 12, 2016

Ad

6 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: 2004 Nissan Murano, back door can't open

I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.

Posted on Mar 03, 2009

FixurNissan

James DeBow

  • 63 Answers

SOURCE: 2003 Nissan Murano Driver door won't lock or unlock with keyfob

The key fob is the remote. But the remote type that works like a key. The remotes that you just need to carry on you to start the car or truck. That is a Key Fob.

Thanks Jay!

Posted on Jul 31, 2009

Anonymous

  • 86 Answers

SOURCE: Nissan Murano (05) Power Locks Sticking

The door lock actuator in that door is weak. Need to replace it.

Posted on Feb 04, 2010

Anonymous

  • 1 Answer

SOURCE: 2003 Nissan Murano hatch back door won't unlock or open

I have a 2004 Murano. I opened the small hatch and with a screw driver and someone on the outside managed to open the hatch. The problem appears to be bent pieces inside. After straightening them out and using a good silicon spray, mine works again. It should be lubricated quite frequently.

Posted on Apr 25, 2010

DJTait

  • 1 Answer

SOURCE: 2005 nissan murano door lock

The Body Control Modual is not recieving a feed back from the passenger door lock confirming the unlock command and is therefore not energizing the rear hatch. There is no physical lock on the hatch - just yes or no for power from the BCM.

Posted on Jul 19, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas door lever wont open


Press the unlock button every time you want to open the fuel door. The Fuel Door is connected to the rest of the locks in the murano.

Jun 26, 2013 | 2004 Nissan Murano

1 Answer

2005 nissan murano door lock


The Body Control Modual is not recieving a feed back from the passenger door lock confirming the unlock command and is therefore not energizing the rear hatch. There is no physical lock on the hatch - just yes or no for power from the BCM.

Apr 01, 2012 | 2009 Nissan Murano

1 Answer

Passenger door and liftgate do not open with remote control or door panel control both start at the same time nissan murano 2005 s model


Liftgate is connected to front RH's door actuator thru back door's "opener switch". Replacing the passenger's door lock actuator will solve the problem.

Jul 25, 2010 | 2007 Nissan Murano SE

1 Answer

The entire lock kit is falling out on driver side Murano. The remote unlocks all but the driver door at times. Other times the door will not open and I am forced to use the key to manually unlock my driver...


Open drivers door, locate plastic plug on inside of door, near latch, across from door lock cylinder. Pop it out. There is a set screw that retains lock cylinder. Tighten set screw.

Jul 09, 2010 | 2003 Nissan Murano

1 Answer

2003 Nissan Murano hatch back door won't unlock or open. Glitchy for a long time, always opened eventually with a ritual of locking/unlocking using the remote/lock on the door, etc. Upon opening,...


I have a 2004 Murano. I opened the small hatch and with a screw driver and someone on the outside managed to open the hatch. The problem appears to be bent pieces inside. After straightening them out and using a good silicon spray, mine works again. It should be lubricated quite frequently.

Nov 05, 2009 | Nissan Murano Cars & Trucks

2 Answers

2003 Nissan Murano Driver door won't lock or unlock with keyfob


The key fob is the remote. But the remote type that works like a key. The remotes that you just need to carry on you to start the car or truck. That is a Key Fob.

Thanks Jay!

Jul 30, 2009 | 2005 Nissan Murano

1 Answer

My 2005 Nissan Murano seems to be possessed. The


Replace the remote battery first, then the remote.

Jul 03, 2009 | 2005 Nissan Murano

1 Answer

Need the steps to programme the remote


Remote Programming Instructions

1. Driver's door OPEN and unlocked, all other doors closed and locked.

2. Insert YOUR key in ignition, DO NOT TURN, remove key.

3. Using the MANUAL lock/unlock button ON THE DRIVERS DOOR, slowly press lock and unlock 5 times (count the lock 5 times and unlock 5 times).

4. Shut door.

5. Open door.

6. Using the lock/unlock button ON THE DRIVERS DOOR, slowly press lock and unlock 5 times (count the lock 5 times and unlock 5 times).

7. With the door open insert your key into the ignition, turn to on position (DON'T START), wait 5 seconds. Turn off and remove key.

8. Locks should cycle once (Car will lock and then unlock once). If they don't cycle or they cycle more than once, do steps 1-7 over.

9. Now using the remote, push lock button, hold for one second,
release. The locks should cycle once. If not, start over and go slower.

10. Close the door. Open the door. Press the lock button on the remote. The locks should cycle. Close the door. Press the lock button on the remote, the doors should lock. Press again and the doors should unlock.

Jun 02, 2009 | 1995 Lexus LS 400

2 Answers

Nissan Murano 2005 SL keyless entry remote programing, got a used remote, how can I program it?


Close all vehicle doors, LOCK doors using drivers side switch.

Insert key all the way into the ignition, (do not turn) remove key.

Repeat this step 5 times. (6 total)

Hazards should flash to indicate program mode.

Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.

*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press any button on remote, hazards should flash. Repeat step as necessary.

Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.

Source

Aug 06, 2008 | 2005 Nissan Murano

Not finding what you are looking for?
2005 Nissan Murano Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...