Going into limp mode
SOURCE: Mercedes Benz C180 Fault Message Brake Assist.Visit Workshop BAS
Hi there
BAS is the Brake Assist System and if there is a malfunction it would
only come into play in an Emergency stop while applying full pressure.
BAS applies full braking force because people tend to lighten up their
pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.
Kind regards
Dustin Ellse
SOURCE: how do i reset the clock in a ml350 mercedes benz
Press services ,left of screen,then system,right ofscreen
Use up/down/left/right on rotary button bottom right/screen
SOURCE: My low beam light bulb
well this is not easy unless you make a accessby removing anything in the way,or just take the headlight out ,How did you manage to open the bonnet as these vehicles from around this year started using a sealed bonnet that only the dealers can open with a special electronic key that uses rolling encrypted software.
SOURCE: I have an engine fault code of p0170 on a mercedes
hi this is showing fuel trim bank 1 malfunction, this could be caused by the following things, intake leak, AIR system, fuel pressure/pump, injector/s EVAP canister purge valve, or HO2S ( air fuel mix incorrect) if it starts and runs fine, i do not think it will be fuel pump, or the injectors as this would make it run rough or even not start at all, if it was an intake leak, you would be suffering from high rev's when you start the car and would take a long time for the rev's to come down, so really, that just leaves the HO2S (sensor/s) these are located one on the exhaust manifold ( from engine follow exhaust manifold you will come to a things sticking out with some wires on) this is HO2S sensor bank 1, or if you look under the car on the exhaust, just past the catalytic converter you will see the same thing, this is HO2S sensor bank 2, it may be either of these, but i possibly would go for the first one, EVAP..it could be, if you have an air leak on it, the EVAP can be found under the hood/bonnet, at the front on the right hand side as you look into the engine/motor bay just in front of the screen was bottle...hope this helps
SOURCE: reset service code B mercedes
Welcome to FIxYa.com
Reset Service Indicator
1. Insert key into ignition, switch to position "1". The mileage counter has to be
displayed.
2. Press repeatedly until the TRIP option is highlighted.
3. Press and hold and within 1 second press and hold both for 5
seconds. The shop menu is displayed.
4. Press repeatedly until "Assyst Plus" is highlighted and confirm with .
Options "Service Data" and "Full Service" are displayed.
5. Press until "Full Service" is highlighted. Confirm with .
6. Press until "Conf. Full Serv." is highlighted, confirm with . The display
shows "Service carried out?."
7. Press to select "Yes". Confirm with . "Cannot be undone" displays.
8. Press until "Confirm" is highlighted. Confirm by pressing . The display
reads "Full Service carried out".
9. Confirm by pressing .
MB
Regards, Lee Davidian
Thank you for using FixYa.com
720 views
Usually answered in minutes!
×