SOURCE: bolt torque specs
I have used Haynes service manuals for (hate to admit it) many decades and I recommend you check to see if this one:
http://www.amazon.com/Haynes-Toyota-Automotive-Repair-Manual/dp/1563923513
doesn't cover your engine.
I have found darned few 'holes' in their coverage.
Auto parts stores carry these and I suspect that even though sealed, the sales people will not give you too hard of a time if you explain you want to insure you are getting what you need.
Haynes is not the same as it was 20 years ago before they were acquired by Chilton but the price/utility ratio is still pretty good.
Mostly I'm annoyed by the move to cheaper paper (newsprint)that is fussier, picks up dirt, tears more easily than the better paper of yore.
SOURCE: 2005 Tucson
camshaft sprocket bolt 58-72 ft. lbs. crankshaft pulley bolts 108-132 ft. lbs. crankshaft pulley center bolt 80-94 ft. lbs. cylinder head bolts cold engine 65-72 ft. lbs. warm engine 73-80 ft. lbs. cylinder head rear cover bolts 69-86 in. lbs. flywheel/Driveplate bolts 94-101 ft. lbs. intake/Exhaust manifold nuts/Bolts 11-14 ft. lbs. jet valves 13-16 ft. lbs. main bearing cap bolts 36-39 ft. lbs. oil pan bolts 51-69 in. lbs. oil pan nuts 43-60 in. lbs. oil pan drain plug 33 ft. lbs. oil pump cover bolts 72-84 in. lbs. oil pump relief valve plug 29-36 ft. lbs. oil pump sprocket nut 25-28 ft. lbs. Rear oil seal retainer bolts 84-108 in. lbs. rocker arm shaft bolts 14-15 ft. lbs. rod bearing cap nuts 23-25 ft. lbs. silent shaft sprocket nut 22-28 ft. lbs. spark plugs 15-21 ft. lbs. thermostat housing-to-Engine bolts 86-114 in. lbs. timing belt tensioner bolt 32-40 ft. lbs. valve cover bolts 43-61 in. lbs. water pump-to-Engine bolts alternator brace bolt 14-20 ft. lbs. all others 9-11 ft. lbs. water pump pulley bolts 72-84 in. lbs.
SOURCE: head bolt torque specs and timing marcs for a 94 volvo 960 6cyl
you do 14 foot pounds then 45 foot pounds then a 120 degree turn.if aluminum heads are what you have
SOURCE: specs
Well I just looked up the specs for you for the 2.7 ltr. I hope this is what you want.
Cam Caps 105 in.lbs.
Cam Sprocket 250 in.lbs.
Crank Dampener 125 ft.lbs.
Cylinder Head Cover 105 in.lbs.
Here is an illustration of the timing chain set up. Be aware these marks are lined up with the three sets of plated links on the chain. You should easily identify them if you have a new chain. You may have to clean an old chain to see them.
Good luck with this and let me know how it goes for you.
1,769 views
Usually answered in minutes!
×